Installing And Removing The Battery Pack - DeWalt DCD200 Manual De Instrucciones

Cable Removal from the Drain Snake and
Cable Drum Installation

WARNING: To reduce the risk of injury, wear safety
goggles or glasses with side shields. Always wear
leather gloves with latex gloves inside. The cable is
under stress and can unwind unexpectedly. Cable end
feature may be sharp.
Remove the cable for cleaning after each use.
To remove the cable:
1. Remove the battery pack from the tool.
2. Pull the front handle
10
unlocked position.
3. With the tool supported vertically, remove the four
screws from the drum cover

WARNING: The cable is under stress and can uncoil
unexpectedly. Keep pressure on the drum cover so it
does not uncoil.
4. Carefully lift the drum cover up, reach underneath to
hold the cable firmly while pulling off the drum cover
and front handle 10 to expose the inner drum
5. Remove the cable from the drum cover and front
handle and tuck it into the inner drum. Set the drum
cover aside.
6. Carefully remove the inner drum with cable from
the drain snake.
7. When cleaning the cable, carefully uncoil the cable from
the inner drum. Refer to Cleaning under Maintenance.
To install the cable:
1. Remove the battery pack from the tool.
2. Pull the front handle
10
unlocked position.
3. Remove the four screws from the drum cover
4. Fully wind the clean, dry cable into the inner drum
following the cable direction symbol

WARNING: Winding the cable in the wrong direction
could cause the tool to apply excessive torque causing
the cable to kink during bind up.

WARNING: Never install a new cable by threading
it through the front handle on the tool. Always
disassemble the drum cover so you can be sure the
cable is wound in the proper direction.
5. Place the inner drum with cable back into the tool.
6. Carefully pull the cable bulb end
drum and feed it through the front handle.

WARNING: The cable is under stress and can unwind
unexpectedly. Keep pressure on the cable so it does
not unwind.
7. Place the drum cover and front handle over the inner
drum and reinstall the four screws. Tighten securely.
nOTE: If the unit is unbalanced and/or vibrates
unnecessarily, the cable may be wound poorly.
out away from the tool to the
9 .
12 .
out away from the tool to the
9 .
12
14 (Fig. A).
out of the inner
13
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

WARNING: Always wear eye and other protective
equipment appropriate to the task.

WARNING: Always wear leather work gloves with
latex gloves inside.

WARNING: Do not operate if more than 6" (15 cm) of
cable is outside of pipe or drum.

WARNING: The cable can whip or tangle.

WARNING: Do not hold cable while it is turning.

WARNING: Cable end feature may be sharp.

Installing and Removing the Battery Pack

9
(Fig. D)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 6 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. D
5
Proper Hand Position (Fig. E)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle and one hand on the front handle grip
3
English
5 into the tool handle, align the
.
10
6
9