NEVER vacuum liquids with the hydro filter when stepping on water or wet
floors. If it were indispensable to step on a humid or wet floor to vacuum
water, do not touch for any reason, the metallic parts of any electric
appliance, lamp or switch.
DO NOT carry the appliance with your hand while using the machine to
clean.
The water basin must be empty before beginning the cleaning and must not
vacuum more than 2.9 liters; the basin's water level MUST NEVER surpass the
height of the central pole, otherwise, they hydro filter begins to vibrate or
shake.
5. Special care and safety instructions
WATER: Do not operate your hydro filter for a long time without changing
the water. When it is observed that the water is filling too much with dust and
lint, empty it and fill it with clean water instead. The correct water level
corresponds to the height of the basin's central pole.
6
HOSE WITH CURVED TUBE: After vacuuming liquids, hold the curved tube
fastened to the hose for one minute. For its internal cleaning, remove the air
discharge lid of the hydro filter; assemble the hose coupling to the union ring,
connecting next the hose's soft ending to the vacuuming intake. Turn on the
motor and shake the hose. Any material adhered inside the hose will be
vacuumed into the water basin.
BASIN: When you finish cleaning your home, always empty the basin after
each use. To store, keep the basin separate from the hydro filter.
THE TURBINE IS THE HEART OF YOUR HYDRO FILTER:
Disconnect, remove and clean the turbine after each use.
Wash it inside and outside with soap and water, using the brush provided for
this purpose. Dry it and place it again in its position matching the guides as
shown in the drawing. Fasten the bolt with your hand until adjusting it
correctly to the flat border of the turbine, without forcing it. The turbine
separates the dirty water from the airflow, and the adequate care is
important for the appliance's optimum operation. If the turbine is damaged