Assembly Procedures - Tanaka TCG 24ECP (SL) Manual De Instrucciones

English

ASSEMBLY PROCEDURES

Installation of handle (Fig. 1)
Attach the handle to the drive shaft tube with the
angle towards the engine.
Adjust the location to the most comfortable position
before operation.
Make sure to securely attach the handle with the 2
bolts.
1
NOTE
If your unit has handle location label (1) on drive
shaft tube, follow the illustration.
WARNING
Do not use metal or plastic blade cutting
attachments with loop handle type.
Installation of cuttingt attachment guard
WARNING
● Do not start or operate unit unless each
guard is properly assembled to unit.
● If an incorrect or faulty guard is fi tted, this
may cause serious personal injury.
CAUTION
Some cutting
equipped with sharp line limiters. Be careful
with handling it.
Aligning to the position indicated by the guard
location label (2), fi rmly secure the cutting
attachment guard to the drive shaft tube with the bolt
(3) and guard bracket (4). (Fig. 2)
8
Fig. 1
attachment guards
Installation of cutting attachment
WARNING
● Install the
and securely as instructed in the handling
instructions.
If not attached properly or securely, it may
come off and cause serious and/or fatal injury.
● Do not install or remove cutting attachments
while the engine is running.
● Always use
attachments and metal fi ttings.
Installation of semi-auto cutting head
These models come with the parts installed.
1. Function
Automatically feeds more nylon cutting line
when it is tapped at low rpm (not greater than
4,500 min ).
–1
Specifi cations
Type of
Code No. attaching
screw
Female
6696454
are
screw
Applicable nylon cord
Cord diameter: 1/8˝ (Φ3.0 mm) Length: 6.5 ft (2 m)
Cord diameter: 3/22˝ (Φ2.4 mm) Length: 13 ft (4 m)
2. Precautions
○ The case must be securely attached to the cover.
○ Check the cover, case and other components for
cracks or other damage.
○ Check the case and button for wear.
If the wear limit mark (5) on the case is no longer
visible or there is a hole in the bottom (6) of the
button, change the new parts immediately.
(Fig. 3)
3
2
4
Fig. 2
cutting attachment
genuine Tanaka
Size of
Direction of
attaching
rotation
screw
M10×P1.25-
Counterclockwise
LH
properly
cutting