Safety Notes; Applications; Mounting - IMG STAGELINE RGBL-82DMX Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
– Selection of the show programmes 1 to 9 and the
colour transition function with button FUNCTION
The LED of button MODE flashes slowly.
– Adjustment of the running speed for the selected
programme in three steps
The LED of button MODE flashes quickly.
Note: For control via the remote control no DMX signal must
be present at the DMX INPUT (8).

2 Safety Notes

The unit corresponds to all required directives of the
EU and is therefore marked with
WARNING The unit uses hazardous mains voltage
(230 V~). Leave servicing to skilled per-
sonnel only and do not insert anything
into the air vents; inexpert handling may
result in electric shock.
Please observe the following items in any case:
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity, and heat (admissible ambient temperature
range 0 – 40 °C).
G
Do not place any vessels filled with liquid, e. g. drink-
ing glasses, on the unit.
G
Do not operate the unit or immediately disconnect
the mains plug from the mains socket
1. if the unit or the mains cable is visibly damaged,
2. if a defect might have occurred after the unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by skilled per-
sonnel.
G
Never pull the mains cable for disconnecting the
mains plug from the mains socket, always seize the
plug.
G
For cleaning only use a dry, soft cloth, never use
chemicals or water.
G
No guarantee claims for the unit and no liability for
any resulting personal damage or material damage
will be accepted if the unit is used for other purposes
than originally intended, if it is not safely mounted or
not correctly operated, or if it is not repaired in an
expert way.
G
Important for U. K. Customers!
The wires in this mains lead are coloured in accord -
ance with the following code:
green/yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug, pro-
ceed as follows:
1. The wire which is coloured green and yellow must
be connected to the terminal in the plug which is
.

3 Applications

The light effect panel RGBL-82DMX is suitable for
applications on stage, in discotheques, and party
rooms. As a light source, it has 240 super bright LEDs
which have a low power consumption, a low heat
development, and a long life. With the LEDs, colour
transitions, running light and stroboscopic effects are
possible. Several RGBL-82DMX units may be com-
bined to a light wall.
DMX light controller (27 DMX control channels, switch-
able to 24, 15, 9, or 6 channels). However, it can also
be operated on its own or with the remote control LC-3
available as an accessory.

4 Mounting

1) Use the holding support (1) to suspend the unit ver-
2) For fixing to a cross bar or for e. g. a horizontal
3) When using the mounting brackets (2) to align the
marked with the letter E or by the earth symbol
or coloured green or green and yellow.
2. The wire which is coloured blue must be con-
nected to the terminal which is marked with the
letter N or coloured black.
3. The wire which is coloured brown must be con-
nected to the terminal which is marked with the
letter L or coloured red.
Warning – This appliance must be earthed.
If the unit is to be put out of operation definiti-
vely, take it to a local recycling plant for a dis-
posal which is not harmful to the environ-
ment.
The light effect panel is designed for control via a
tically from a wall. By mounting several RGBL-
82DMX next to each other and above each other, a
light wall of any desired extent can be created.
attachment screw the two mounting brackets (2)
according to fig. 1 to the rear side of the unit. For
fasten it to a cross bar use two C hooks (e. g. the
item PAST-1 from the product range of "img Stage
Line").
WARNING The unit must be mounted in a safe
and expert way. If it is installed at a
place where people may walk or sit
under, it must additionally be se-
cured (e. g. by a safety rope; fix the
safety rope in such a way that the
maximum falling distance of the unit
may not exceed 20 cm).
unit, release the setscrews of the brackets. Adjust
the desired inclination of the unit and retighten the
screws.
,
GB
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

38.4010

Tabla de contenido