Hitachi C 12FSA Manual De Instrucciones E Instrucciones De Seguridad página 20

English
For miter cut setting
If the turntable has been set to either of the angles described, move the turntable adjusting side handle
a little to the right and left to stabilize the position and to properly align the miter angle scale and the tip
of the indicator before the operation starts.
For bevel cut setting
Move handle on bevel section to the right and left and check that the position is stable and that the
bevel angle scale and the tip of the indicator are properly aligned. Then tighten the clamp lever.
Type of
Crown
Molding
45° Type
38° Type
(1) Setting to cut crown moldings at positions q and r in Fig. 28 (see Fig. 29; tilt the head to the left):
q Turn the turntable to the right and set the Miter Angle as follows:
* For 45°type crown moldings: 35.3° ( mark)
* For 38°type crown moldings: 31.6° ( mark)
w Tilt the head to the left and set the Bevel Angle as follows:
* For 45°type crown moldings: 30° ( mark)
* For 38°type crown moldings: 33.9° ( mark)
e Position the crown molding so that the upper surface (A in Fig. 27) contacts the fence as indicated in
Fig. 30.
(2) Setting to cut crown moldings at positions w and e in Fig. 28 (see Fig. 31; tilt the head to the left):
q Turn the turntable to the left and set the Miter Angle as follows:
* For 45°type crown moldings: 35.3° ( mark)
* For 38°type crown moldings: 31.6° ( mark)
w Tilt the head to the left and set the Bevel Angle as follows:
* For 45°type crown moldings: 30° ( mark)
* For 38°type crown moldings: 33.9° ( mark)
e Position the crown molding so that the lower surface (B in Fig. 27) contacts the fence as in Fig. 32.
q
Miter Angle Scale
Fence
A
20
To process crown molding at
positions 1 and 4 in Fig. 28.
Miter Angle Bevel Angle
Setting Setting
right 35.3° left 30°
( mark) ( mark)
right 31.6° left 33.9°
( mark) ( mark)
Head
Bevel Angle Scale
r
Fence
Base
Turntable
Fig. 29
B
Table on Base
Fig. 30
To process crown molding at
positions 2 and 3 in Fig. 28.
Miter Angle
Setting
right 30° left 35.3°
( mark) ( mark)
right 33.9° left 31.6°
( mark) ( mark)
Head
Bevel Angle Scale
w
Fence
Miter Angle Scale
Fig. 31
Fence
B
Table on Base
Fig. 32
Bevel Angle
Setting
left 30° right 30°
( mark) ( mark)
left 33.9° right 33.9°
( mark) ( mark)
e
Base
Turntable
A