Hitachi C 8FB2 Manual De Instrucciones E Instrucciones De Seguridad página 20

English
(2) Setting to cut crown moldings at positions w and e in Fig. 28 (see Fig. 31):
q Turn the turntable to the left and set the Miter Angle as follows:
* For 45°type crown moldings: 35.3° ( mark)
* For 38°type crown moldings: 31.6° ( mark)
w Tilt the head to the left and set the Bevel Angle as follows:
* For 45°type crown moldings: 30° ( mark)
* For 38°type crown moldings: 33.9° ( mark)
e Position the crown molding so that the lower surface (B in Fig. 27) contacts the fence as in Fig. 32.
q
Miter Angle Scale
Fence
11. Groove cutting procedures
Grooves in the workpiece can be cut as indicated in Fig. 33 by adjusting the 8mm depth adjustment bolt.
Cutting depth adjustment procedure:
(1) Loosen the 8mm wing nut and turn the 8mm depth adjustment bolt by hand.
(2) Adjust to the desired cutting depth by setting the distance between the saw blade and the surface of
the base (see b in Fig. 33).
(3) The 8mm wing nut must be properly tightened after the adjustment has been completed.
NOTE:
When cutting a single groove at either end of the workpiece, remove the unneeded portion
with a chisel.
20
Head
Bevel
Angle Scale
r
Turntable
Fig. 29
A
B
Table on Base
Fig. 30
Cut grooves with saw blade
a
b
Fig. 33
w
Fence
Fence
Base
Miter Angle Scale
Fence
B
8mm
Wing Nut
Bottom Line of
the Groove
Turntable
Head
Bevel
Angle Scale
e
Base
Turntable
Fig. 31
A
Table on Base
Fig. 32
8mm
Depth Adjustment Bolt
Fig. 34