Ryobi RP4200 Manual Del Operador página 7

WATERPROOF RATING
The IP57 waterproof rating denotes that the product is totally
protected against dust and against the effect of immersion
up to 1 m.
Do not use this camera for diving or any other prolonged
underwater use. If the camera is exposed to rain or immersed
in water, wipe it dry as soon as possible.
The waterproof rating applies only when the the battery cap
and the USB/SD card slot door are securely closed.
WATERPROOF FEATURE
NOTE: Moisture or condensation does not indicate a mal-
function of the waterproof feature.
Changes in temperature (such as moving the camera from
a cold place into a warm place) may cause condensation
in the form of water droplets on the lens or the inside of the
camera. This is normal for all cameras. If this happens, turn
the camera off, open the SD card/USB access door, and
remove the battery cap and battery. Place it in a cool, dry
area and leave the battery cap and USB door open. Wait at
least an hour before you turn it on again.
After using the camera in water, check the inside of the SD
card/USB access area. You may see water droplets along
the edge of the cavity. This is normal. If so, carefully wipe the
area dry with a clean cloth before closing the cover.
POWER BUTTON
See Figure 3, page 12.
The on/off (POWER) button is located on the top right side
of the camera. Press and hold the button to turn the camera
ON. Press and hold again to turn the camera OFF. You will
hear a tone when the camera comes on and shuts down.
When the camera is turned on, the frame icon will appear in
the center of the screen and the LCD will show the image
the lens is pointing at.
NAVIGATION KEYS
See Figure 1, page 11.
The arrows surrounding the OK button are used to navigate
through menus and thumbnails. They perform a variety of
functions and are used to select options in Camera mode,
Video mode, and Utility mode.
LOADING THE SD CARD
See Figure 4, page 12.
 Push open the lock on the SD card/USB access door on
the side of the camera.
 Be sure to insert the card in the direction shown. Push
the card all the way in and allow it to properly seat itself
in the slot.
 Close the access door and slide the lock to the closed
position.
OPERATION
FORMATTING THE SD CARD
It is recommended that new SD cards be formatted before
the first use. SD cards may be reformatted if there are
problems with the images that may be caused by the card.
Reformatting the card removes all previously stored data.
 Select Format Memory. See Basic Operation Settings later
in this manual.
 Use the right and left navigation keys to select Yes or
No.
 Press the OK button. The card should now be formatted.
SHUTTER BUTTON
See Figure 3, page 12.
The shutter button is located on the right front of the camera.
To take a picture:
 Turn the camera on and select your shot on the LCD
screen.
 Depress the shutter button halfway to focus. When the
shot is in focus, the frame icon will turn green.
 Fully depess the shutter button. It will click as you take
the shot. Your picture will appear on the LCD display.
PLAYBACK BUTTON
See Figure 1, page 11.
Activates Playback mode. The last recorded photo or video
clip will be displayed. Use the Navigation keys to view other
stored photos and video clips.
MEMO BUTTON
See Figure 1, page 11.
When in Playback mode, memo is used to record audio and
memos that are attached to the currently selected picture.
MENU BUTTON
See Figure 1, page 11.
The menu button opens and exits the menu options for your
current mode of operation (Camera. Video, or Utility mode).
It also exits to Camera mode if pressed while you are in a
set-up options menu.
CAMERA MODE
See Figure 3, page 12.
Your camera's features can be set to your preferences for
a variety of applications. The Camera mode button is on
the top left of your camera. To view the menu of available
settings, press the menu button. The following options will
appear.
7