Setting Into Operation - IMG STAGELINE STROBE-15LED Manual De Instrucciones

2. The wire which is coloured blue must be con-
nected to the terminal which is marked with the
letter N or coloured black.
3. The wire which is coloured brown must be con-
nected to the terminal which is marked with the
letter L or coloured red.
Warning – This appliance must be earthed.
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment.
3 Applications
The unit STROBE-15LED serves to create strobo-
scope light e. g. on stage, in clubs or festival rooms.
As a light source, 3 powerful LEDs of 5 W each are
used which have a long life and a low power con-
sumption. An integrated microphone allows the
LEDs to flash to the beat of the music.
The stroboscope is designed for control via a
DMX light controller (2 DMX control channels).
However, it can also be operated without controller,
either as an individual unit or interconnected with
several STROBE-15LED units in the master/slave
mode.
4 Mounting / Setting-up
G
To prevent heat accumulation within the unit,
always place it so that a sufficient air circulation
is ensured during operation. The air vents at the
housing must not be covered.
G
The distance to the illuminated surface should be
50 cm as a minimum.
WARNING The unit must be mounted in a safe
and expert way. If it is installed at a
place where people may walk or sit
under it, it must additionally be
secured [e. g. by a safety rope; lead
the safety rope through the safety lug
(7) and fix it so that the maximum
falling distance of the unit would not
exceed 20 cm].
1. Fix the unit via one or two brackets (1), e. g. with
a stable mounting screw to a cross bar.
To align the unit, release the two locking
screws (2) at the brackets. Adjust the desired
inclination of the unit and retighten the screws.
2. As an alternative, the unit can also be set up as
desired. For this purpose spread the brackets
below the unit so that they serve as a support
( fig. 2). Then tighten the locking screws.

5 Setting into Operation

WARNUNG Never look directly into the light
source; this may cause eye damage.
Please note that stroboscope effects
may trigger epileptic seizures with
photosensitive persons or persons
with epilepsy!
1) To switch on, connect the mains cable supplied
to the mains jack (9) and the mains plug to a
socket (230 V~/ 50 Hz). The last menu setting is
activated and shown on the display (10).
Note: If the display shows
the control by a DMX light controller (
to slave mode ( chapter 6.1.2), however, it does not
receive any control signals.
2) To switch off the unit, disconnect the mains
plug.
For a more convenient operation it is recom-
mended to connect the unit to a socket which can
be switched on and off via a light switch.
Caution: The unit must not be connected to the
mains voltage via a dimmer!
6 Operation
The adjustments of the unit are made via a system
menu to be operated by means of four buttons (11)
and the display (10) on the rear side. The menu
structure is shown in fig. 1 on page 2.
6.1 Operation without DMX light controller
6.1.1 Operation as an individual unit
For the operation as an independent individual unit
three operating modes are available:
a) Automatic mode
Setting light gradually getting brighter
and darker
Setting stroboscope light with fixed
flash frequency
b) Music control
Setting multiple-flash stroboscope:
3 flashes per music pulse
,
the unit is adjusted to
chapter 6.2) or
GB
9