Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Column Lock Handle
Referring to Figure 5:
Thread the column lock handle (D) into the table
bracket (E).
Figure 5
Table Installation
Referring to Figure 6:
1. Place the table (A) on the bracket (B).
2. Tighten the table lock handle (C).
Figure 6
Head Assembly
Referring to Figure 7:
1. With the aid of a second person, carefully lift the
head onto the column top and slide it down into
position
The head assembly is heavy!
Use care when lifting onto the column!
2. Rotate head assembly until sides of the pulley
cover are parallel with the sides of the base.
3. Tighten two setscrews (A) with a 5mm hex
wrench (provided) until they are snug.
4. Install three downfeed handles (B) into the
downfeed hub (C).
Chuck and Arbor Installation
Referring to Figure 8:
1. Thoroughly clean arbor (A), chuck (B) and
spindle (C). Any grease or residue in these
areas can cause the pieces to separate and
create a safety hazard as well as damage to the
tool.
2. Twist the chuck (B) to retract the chuck jaws if
they are exposed.
3. Push chuck (B) by hand onto the arbor (A), and
slide assembly firmly up into the spindle (C).
4. Turn the arbor and chuck assembly until the
tang (B) on the arbor (C) engages the slot at the
end of the spindle.
Use a single tap from a rubber mallet, or a hammer
and a block of wood, against the bottom of the chuck
to seat the chuck securely onto the arbor.
directly against the chuck, as this may damage
the chuck.
9
Figure 7
Do not use a steel hammer
Figure 8
Publicidad
Capítulos
Tabla de contenido
