Fontastic RTX4 Manual Del Usuario página 4

GB
Receive mode (RX) operation
Pairing with a Bluetooth transmitter (e.g. Smartphone, Tablet, Computer)
1. Connect the transceiver to your home stereo and the transceiver
(connector „Audio Out") using a jack or Toslink cable.
2. With transceiver powered on and TX/RX toggle switch set to „RX". If
the LED light is not fl ashing alternately, slide and hold the spring-
loaded slider (Multi-Function Switch) all the way to the right for about
4 seconds until the LED indicator light will fl ash red and blue.
3. Place your Bluetooth transmitter within 1 meter range of transceiver,
enable Bluetooth on your device and enter Bluetooth settings.
4. Scan listed Bluetooth devices and select „RTX4" to connect. Once
connected, the LED indicator will turn solid blue or green.
5. Make sure the proper audio output source is selected on transceiver.
Match the corresponding audio output on the transceiver by selecting
between Optical and AUX audio source using the multi-function
switch.
6. The music on your Bluetooth transmitter will now play through your
home stereo.
Multipoint streaming – Pairing with two Bluetooth
receivers/transmitters
The transceiver allows you to use two devices at the same time.
In transmit mode (TX) you can, for example, connect two headphones
so that the sound from your music source can be played on both head-
phones at the same time.
In receive mode (RX), for example, you can connect two smartphones
so that the sound can be changed from one smartphone to another
without need to disconnect one and connect the other smartphone.
1. Connect your fi rst device to the transceiver by following the previous
instructions.
2. Get transceiver in pairing mode by sliding and holding the MFS for
about 4 seconds until the LED indicator fl ashes alternately red/blue.
3. Set your second device to be connected into paring mode and wait
until it is connected. If the device is not connected during the fi rst
attempt, repeat the procedure.
4. As soon as the second device is connected, the LED indicator will turn
solid blue or green.
5. Reset the multifunction switch to the correct position (OPT or AUX).
3