Operation; Independent Operation; Operation With The Remote Control - Leuchtkraft LED-162RGBW Manual De Instrucciones

When multiple LED-162RGBW are used, the jack
POWER LINK OUTPUT (4) of the first unit can be
connected to the mains jack (3) of the second
unit . For this, a mains cable with a 3-pin IEC
plug and a 3-pin IEC inline jack is required (e . g .
cable AAC-170/SW from MONACOR) . The sec-
ond unit can then be connected to the third unit
etc . until all units are connected in a chain . Thus,
it is possible to connect up to 55 LED-162RGBW .
The jack POWER OUT can also be used to
provide power to other (light effect) units . How-
ever, to reduce the risk of short-circuit and fire
due to overload, the current in the mains jacks
(3, 4) and the mains cable must not exceed 10 A .
The fuse (5) will not protect these jacks .

5 Operation

The following control buttons (12) are available
in the menus for selecting the operating mode
and changing settings:
Button Function
To select the operating mode /
MENU
to return to the previous function
UP To go to the next menu item / increase the value
DOWN to go to the previous menu item / reduce the value
To call up a submenu /
ENTER
to save a setting
Fig. 4 Control buttons
The menu structure with all operating steps can
be found on page 3 .

5.1 Independent operation

The following modes are available for independ-
ent operation of the light effect unit:
automatic light show
music-controlled light show
light show without rotation
white running light, 18 programs
1) Press the button MENU repeatedly until the
display indicates the mode desired .
2) Press the button ENTER . For the modes
and
( menu structure on page 3) .
☞
3) Use the button UP or DOWN to set the func-
tion or value desired .
12
, press ENTER a second time
4) Press the button ENTER to confirm and (at the
same time) save the setting . The system will
automatically go to the next setting option
(does not apply to
5) Repeat steps 3 and 4, depending on the set-
ting options of the operating mode .
6) For a music-controlled light show, use the
control SENS (8) to set the microphone sen-
sitivity in such a way that the light show is
in accordance with the beat of the music .
Note: In the mode
running light will switch off after 5 seconds if no
sound event is received . They will be switched on
again by the next sound event .
Mode Setting options Function
automatic
light show
...
music-
controlled
light show
...
...
light pattern ...
w/o rotation
...
...
...
running light
...
Fig. 5 Overview of independent operation

5.1.1 Operation with the remote control

Power supply of the remote control (fig . 3) is
provided by means of a battery . If the remote
control is supplied with the battery inserted,
remove the protective film (to protect the battery
against discharge) from the battery support: The
remote control will then be ready for operation .
When pressing a button, always point the re-
mote control to the light effect unit . Make sure
that there are no obstacles between the unit
and the remote control .
If the remote control is not used for a longer
time, remove the battery as a precaution so that
the remote control will not be damaged in case
the battery should leak .
) .
, the light pattern and the
Rotating light pattern
and white running light
White running light
Rotating light pattern
Speed
Rotating light pattern
and white running light
White running light
Rotating light pattern
Brightness of red
Brightness of green
Brightness of blue
Brightness of white
Flashing, slow  fast
Running light program
Speed