Features; Assembly; Operation - Ryobi P3330 Manual Del Operador

PRODUCT SPECIFICATIONS
Motor ............................................................................................................................... 18 Volt DC or 120 V, AC only, 60 Hz
Switch .....................................................................................................................................................................Two Speed
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
 Residential and commercial drying of damp or wet
surfaces such as concrete, laminate, and tile floors
NOTICE:
This product is designed to be powered by either a
Ryobi One+ 18V battery pack (DC mode) or by electric
™
™
power (AC mode). Either power source can be used by
installing an approved battery pack or power cord into
the product as described in this manual.

FEATURES

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

INSTALLING/REMOVING BATTERY PACK
See Figures 1 - 2, page 8.
 Place the power switch in the center, or OFF ( O ) position.
 Raise the battery cover.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Lower the battery cover and make sure it is securely
closed.
NOTE: If desired, the battery cover can be locked by
installing a padlock through the holes at the top of the
cover.
 To remove, open the cover and depress the latches on
both sides of the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
WARNING:
Always remove battery pack or unplug extension cord
from your product when you are assembling parts,
making adjustments, cleaning, or when not in use.
Removing battery pack or unplugging extension cord
will prevent accidental starting that could cause serious
personal injury.
NOTE: The battery pack should be recharged after
approximately 5 hours of use to reduce the possibility of
damage. Repeated deep discharge of the battery may
decrease storage capacity and battery life.
6 – English