Features; Assembly; Operation - Ryobi P738 Manual Del Operador

PRODUCT SPECIFICATIONS
Maximum Pressure ................................................. 0.5 PSI
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
WARNING:
Do not leave items to be inflated unattended while infla-
tor is in use. These items can burst and could cause
serious injury.
NOTICE:
The inflator is capable of inflating to 0.5 PSI. To avoid
over inflation, carefully follow instructions on items to be
inflated. To avoid product damage, never exceed recom-
mended pressures.

FEATURES

Duty Cycle ........................................................ Continuous

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

APPLICATIONS
You may use this inflator for the purpose listed below:
 Large (high volume) nozzle: Cleaning work surfaces,
inflating air mattresses and other large inflatables
 Small nozzle: Inflating beach balls and similar inflatables
 Deflation port: Quickly deflating items
NOTE: The inflator is not designed for commercial applica-
tions.
TO INSTALL/REMOVE BATTERY PACK
See Figure 1, page 7.
To install:
 Place the battery pack in the product. Align the raised
rib on the battery pack with groove in the battery port.
 Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
tool before beginning operation.
To remove:
 Depress the latches on both sides of the battery pack to
release the battery pack and remove it from the tool.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
WARNING:
Battery tools are always in operating condition. Always
remove battery pack from your tool when you are as-
sembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
5 — English