Control Elements; Installing The Hob; Selecting The Installation Location - Dometic EK 1600 Instrucciones De Uso

Installing the hob

5.3

Control elements

fig. 1
No. in , page 2 Description
1
2
6 Installing the hob
The hob can be installed in your kitchen worktop.
6.1

Selecting the installation location

When selecting the installation location, observe the following instructions:
 Select a well-ventilated location for the device.
 Ensure the following minimum clearances (fig. 2, page 2):
– 150 mm to the side walls
– 170 mm to the back wall
– 500 mm between the burner and horizontal surface above the hob
– 10 mm between the bottom of the hob and the surface base.
 Ensure that there are no draughts in the installation location.
If the hob is installed in an open cockpit or other exposed location, then
also install an additional wind guard.
 Do not operate the device in rooms that are potentially explosive.
 If gimbals are used, ensure that the stove can swing freely.
 Ensure you have ample room to swing the gimballed range.
6.2 Installing the hob
NOTICE! Risk of damage!
A
Before drilling any holes, make sure that no electrical cables or oth-
er parts of the vehicle can be damaged by drilling, sawing and filing.
10
Control knob with three settings (zero, large flame and
small flame)
Turn the knob anti-clockwise to open the gas cock.
Turn the knob clockwise up to the stop to close the gas cock.
Pot holder
Dometic EK 1600, EK 3200
EN