Prior To Operation; Discharge Hose Connection; Installation - Metabo TBP 4000 M Manual De Instrucciones

reached due to poor pressure
conditions or a defective pres-
sure switch the water can heat
up within the pump as a result
of internal circulation.
Through this the pump and the
connection lines can become
damaged or leaky, allowing hot
water to escape. Danger of
scalding!
 Do not operate the pump
against a closed pressure
line for longer than 5 minu-
tes.
 Unplug the pump and allow
to cool. A specialist must
check the system to make
sure it is in perfect working
order before it can be used
again.
B
Danger! Risk of electric
shock!
 Do not direct water jet
directly against the pump or
other electrical parts! Risk
of fatal electric shock!
 Do not touch the plug with
wet hands! To unplug
always pull at the plug, not
the power cable.
 Connect only to an earthed
outlet that is properly
installed, earthed and
tested. Mains voltage and
fuse protection must corre-
spond to those stated in the
"Technical Specications".
 Protection must be pro-
vided by a residual current
device (RCD) of max.
30 mA capacity.
 The earthed outlet or the
plug connection to an
extension cable must be
located in an area safe
against flooding and pro-
tected from water.
 Use only extension cables
of sufficient lead cross sec-
tion (see "Technical Specifi-
cations"). Unroll cable reels
fully.
 Do not buckle, squeeze,
drag or drive over power
cable and extension cables;
protect from sharp edges.
 Place extension cable so
that it can not get into the
fluid to be pumped.
 Unplug:
 prior to all servicing;
 when persons are in the
swimming pool or garden
pond.
A
Danger by pump fail-
ures!
 If you notice shipping dam-
age while unpacking, notify
your supplier immediately.
Do not operate the pump!
 Before each use check the
pump, especially the power
cable and plug for possible
damage. Risk of fatal elec-
tric shock!
 A damaged pump must be
workmanlike repaired
before it can be used again.
 Do not attempt to repair the
pump yourself! When
repaired inexpertly there is
a hazard of fluid entering
the electrical parts of the
pump.
A
Caution!
To avoid water damage,
e.g. flooded rooms, caused
by pump malfunctions or
defects:
 provide for suitable safety
measures such as the fol-
lowing:
 alarm or
 collection tank with moni-
toring.
The manufacturer is not liable
for any damage caused by:
 improper use of the pump;
 overloading of the pump
through continous opera-
tion;
 failure to operate and store
the pump in a frost-free
environment;
 unauthorised modification
of the pump (repairs to
electrical equipment may
only be carried out by quali-
fied electricians!);
 use of spare parts which
have not been tested and
ENGLISH
approved by the manufac-
turer; or
 use of unsuitable installa-
tion materials (fittings, con-
nection lines etc.).
Suitable installation materi-
als:
 pressure-resistant (min.
10 bar)
 heat-resistant (min.
100°C).

5. Prior to Operation

5.1 Discharge Hose Connec-
tion
The discharge hose is either screwed
directly on the discharge port (6) or con-
nected by means of a multi-adapter (if
necessary secure discharge hose with
hose clamps).
6
5.2

Installation

A
Caution!
 Pump installation and tube well
construction shall only be carried
out by an authorised specialist.
 For initial operation of the deep
well pump follow the instructions
given in the supplementary sheet.
11