•
Do not use unauthorised connections.
This will invalidate the warranty and
could cause fire, electric shock or
injury.
•
Should you decide not to use your
appliance again, cut the power cord
after unplugging it.
4. OPERATION
BEFORE FIRST USE
Clean and rinse the inside of the coffee
machine before using it for the first time
and clean the outside with a slightly damp
cloth.
Operate the coffee machine a couple of
times to get rid of any possible residue. Do
not drink this coffee.
USE OF THE APPLIANCE
To make coffee, proceed as follows:
• Check that the coffee machine is cool
and then unscrew the top container,
holding the bottom container with one
hand and turning anticlockwise.
Warning: Ensure that the gasket (F) and
the top filter (E) are clean, that they are
not damaged and that they are correctly
placed, as shown in Figure 2.
• Fill the bottom container (I) with enough
water for the amount of coffee you
wish to make. The coffee machine has
a mark to indicate how full it should be
(Fig. 3) depending on whether you want
3 or 6 cups of coffee.
Warning: The coffee maker has a safety
valve (H) to prevent excess pressure
(Fig. 4). Do not fill the coffee machine
beyond the height of the valve because
boiling water could come out of the
coffee maker.
• When full, place the coffee filter onto
the bottom base. If you are going to
prepare 3 cups, also use the 3 cup filter
accessory (L). (Fig. 5)
IMPORTANT: Do not use the coffee
machine without water in the container.
• Fill the filter with ground coffee. Bear
in mind that the amount of coffee and
how much you press it down will directly
affect the strength of the coffee (Fig. 6).
• Put the top part of the coffee machine in
place by turning it clockwise. (Fig. 7)
• Once assembled, place the coffee
machine on the base (K) (Fig. 8).
• To switch the coffee machine on, close
the lid and press the 'on' button (J).
This button will light up while the coffee
machine is in operation (Fig. 9).
Warning: The lid must be closed while
the coffee machine is in operation.
• The coffee will start to rise in a couple of
minutes.
USE OF THE 3 OR 6 CUP FILTERS
Depending on how many cups of coffee
you wish to make, you must proceed
differently.
The coffee machine has a mark to indicate
how far you should fill the container,
depending on how many cups of coffee
you wish to make. (Fig. 3)
To prepare a full pot (6 cups) of coffee,
remove the 3 cup filter from the appliance
(L) and fill the container with water up to
the 6 cup level. If you wish to make 3 cups,
fill the pot only up to the 3 cup level.
If you wish to make 3 cups, you should
assemble the 3 cup accessory as well as
the normal filter (Fig. 5).
5. CLEANING
• Before cleaning the appliance, wait until
it has cooled down.
• Remove the appliance from its
connection base.
• Clean the inside of the tube periodically
with soapy water or rinse it under the tap.
• Check the funnel and gasket regularly.
In the event of wear or deterioration,
replace them with original spare parts.
• Check from time to time that the filter
holes are not obstructed. If necessary,
clean them with a pin.
• Do not use abrasive cleaning agents,
degreasers, alcohol, etc. to clean any
part of the coffee machine. Simply wipe
it with a sponge, without wetting any
electrical components.
8