Monacor SIC-520 Manual De Instrucciones página 7

4) Replace the soldering tip (e. g. by soldering tips of
the MONACOR series SIT-5..) and fix the screw
sleeve by turning it with the fingers. In order not to
damage the heating element, the screw sleeve
must not be tightened too much.
5 Notes for Correct Soldering
1) Prior to the operation check the soldering tip for
tight position.
2) Always keep the soldering tip clean and – especi-
ally prior to switching off the soldering station – pro-
vide it with sufficient soldering tin.
3) Prior to soldering clean the parts to be soldered.
4) To protect the soldering station and the soldering
tip, the unit should not be operated at temperatures
of 400°C and more for a longer period of time.
6 Cleaning of the Soldering Station
Prior to cleaning the soldering station must be
switched off and disconnected from the mains! The
housing of the soldering station and the handle of the
soldering iron may be cleaned with a slightly wet cloth
and a small quantity of liquid detergent. Sharp deter-
gents or chemicals must not be used. While cleaning
ensure that no liquid enters into the unit!
7 Specifications
Power supply: . . . . . . . . . . 230 V~/50 Hz/54 VA
Electronic temperature
control: . . . . . . . . . . . . . . . 150-420°C
Dimensions (W x H x D): . . 120 x 95 x 180 mm
Weight: . . . . . . . . . . . . . . . 2.2 kg
According to the manufacturer.
Subject to technical change.
(w/o soldering iron sup-
port)
GB
7