Fell Marine MOB+ Manual De Usuario página 17

1.
2.
3.
NOTICE
4.
5.
6.
7.
8.
9.
17
Mounting the xHUB
Remove the xHUB Nut by turning it.
Attach the External Antenna by turning it
onto the antenna connector at the bottom of
the xHUB.
Drill a hole in your helm for the xHUB. Use
standard 52 mm (2-1/16") hole cup drill to
make the hole.
Be sure not to drill through any existing cables or
equipment mounted or situated on the backside
of your intended xHUB position!
Insert the xHUB Cable and External Antenna
into the hole and then place the xHUB in the
hole.
Place the gasket between the flange under the
top of the xHUB and the surface of the helm/
wall surrounding the hole.
When positioning the xHUB in the helm
or other suitable place, make sure to set
the direction of the xHUB with the battery
indicator at 12 o'clock and the FELL printing
at six o'clock.
Tighten the xHUB Nut from behind to securely
attach the xHUB in the helm. The xHUB Nut
is fitted by applying normal hand force. If the
nut cannot be attached to the xHUB because
of the dash board thickness, the xHUB should
be fastened using a suitable marine adhesive.
Attach the xHUB Cable and the Connection
Cable by connecting the male and female
5-Pin Connectors together on the two cables.
Proceed to connecting the wires, see page 21
"Connecting the wires".