Descargar Imprimir esta página

Messner DS 350 Instrucciones De Servicio página 8

Regulador de velocidad

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 12
GB
People who are not familiar with the operating instructions may not
use the speed controller!
This appliance is not suitable for use by persons (including children) with
limited physical, sensory or mental capabilities or lacking experience and/or
knowledge, except if they are supervised by a person responsible for their
safety or have been instructed in the use of the appliance.
Children should be supervised in order to make sure that they do not play
with the appliance.
Technische gegevens vindt u op het typeplaatje resp. in de tabel op
pag. 1.
Intended use
The intended use of the DS 350 speed regulating device is speed regulation
of 230 VAC asynchronous motors, for example, as they are used in the
following Messner pumps:
eco-X2 4500 - eco-X2 20000
eco-X2 plus 10000 - eco-X2 plus 25000
eco-Tec2 4500 - eco-Tec2 20000
eco-Tec2 plus 10000 - eco-Tec2 plus 25000
power-X2 4000 - power-X2 14000
power-Tec2 4000 - power-Tec2 14000
eco-XN 4500 - eco-XN 16000
MultiSystem MPF 3000 - MPF 13000
Multi-System MP 3500 - MP 10000
Safety instructions
The DS 350 speed regulating device is suitable for indoor household use,
and also for outdoor use, e.g. in the garden or on the terrace. The device
should no longer be operated if it shows visible damage. If you operate
a pump in the well or garden pond with the speed regulating device, the
speed regulating device must be connected to a proper earthing contact
socket outlet with a residual current circuit breaker (RCCB 30 mA). Install
the connection socket in a water-protected area and at least 2 m away from
the edge of the pond (see Fig. A + B).
The electrical installation on garden ponds and wells and the associated
protected area must satisfy the valid directives. Please contact a qualifi ed
electrician.
Commissioning
Plug the speed regulating device into a proper earthing contact socket out-
let. Plug the power supply plug of the pond pump into the speed regulating
device. Turn the knob on the front clockwise to switch on the pond pump.
Turning the knob further clockwise reduces the speed of the pond pump to
the desired value. This also reduces the power consumption. With the
DS 350 speed regulating device the pump can be adjusted from the virtually
full power level (max.) to lowest power level (min.). The minimum value
depends on the respective pump capacity.
6

Publicidad

loading

Este manual también es adecuado para:

168/002974