Renfert Vortex compact Instrucciones De Servicio página 4

During operation
Take care not to damage
the mains lead (e.g. by
driving over, pinching or
dragging). Pull out the
mains plug only directly at
the plug, i.e. not by pulling
at the mains lead.
Before picking up liquids,
the filter bag must be
removed and the function
of the float switch
checked.
If foaming is observed,
stop work immediately
and empty the tank.
Connect to a properly
grounded outlet only.
Maintenance and repair
CAUTION!
Before cleaning and ser-
vicing the cleaner, always
remove the mains plug.
Carry out only mainte-
nance operations des-
cribed in these operating
instructions.
Use only original spare
parts.
Do not make any technical
modifications to the
cleaner.
CAUTION!
Your safety could be
endangered as a result!
For all other maintenance
and repair work, please
contact Denerica or an
authorised specialist
workshop!
2
Electrical equipment
Check the rated voltage of
the cleaner before connec-
ting it to the mains power
supply. Ensure that the
voltage specified on the
rating plate corresponds to
the local mains voltage.
When using an extension
lead or replacing the mains
lead, the lead type speci-
fied by the manufacturer
must always be used.
We recommend that the
power supply to the clea-
ner be connected to a
grounded, GFCI-protected
socket.
When using an extension
lead, observe the minimum
cross-sections of the leads:
Cable length Cross-
feet section
up to 60 14 AWG
60 to 150 12 AWG
Always arrange the
current-carrying parts
(plug sockets, plugs and
connectors) and lay
extension leads so that
the protection class of the
cleaner is maintained.
CAUTION!
Never spray the top
section of the cleaner with
water: Danger for
persons, danger of short
circuits.
The latest edition of the
IEC Regulations and the
NEC must be observed.