And Connections - Monacor ESUB-8F/WS Manual De Instrucciones

Active Subwoofer System
These operating instructions are intended for
users with basic knowledge in audio technol-
ogy . Please read the instructions carefully prior
to operating the unit and keep them for later
reference .
All operating elements and connections
described can be found on the fold-out page 3 .
Contents
1 Operating Elements
and Connections . . . . . . . . . . . 8
2 Safety Notes . . . . . . . . . . . . . 9
3 Applications . . . . . . . . . . . . . . 9
4 Setting Up and Connecting . . . . . 9
4 .1 Stereo input LINE IN . . . . . . . . . . 9
4 .2 Stereo input HIGH LEVEL IN . . . . . 10
4 .3 Power supply . . . . . . . . . . . . . 10
5 Operation . . . . . . . . . . . . . . 10
6 Specifications . . . . . . . . . . . . 11
8
1 Operating Elements

and Connections

1 POWER LED
green subwoofer in operation
red subwoofer in standby mode
2 VOLUME control
3 CROSSOVER control to adjust the cutoff
frequency (50 - 250 Hz) of the low pass filter
4 POWER switch
5 Mains jack for connection to a mains socket
(230 V/50 Hz) by means of the mains cable
provided
6 Support for the mains fuse;
always replace a blown fuse by one of the
same type
7 Stereo signal input LINE IN (RCA jacks)
8 Feed-through output LINE OUT to route the
signals available at the jacks LINE IN to the
amplifier of a speaker system, for example
9 PHASE reversal switch
10 Selector switch
position OFF:
position ON:
position AUTO: switching between the
11 Stereo signal input HIGH LEVEL IN for connec-
tion to the speaker output of an amplifier
There are banana jacks under the protective
caps of the screw terminals .
12 Feed-through output HIGH LEVEL OUT,
connected to the corresponding jacks
HIGH LEVEL IN (11), for connecting the
other speakers
There are banana jacks under the protective
caps of the screw terminals .
always in standby mode
always in operation
modes operation and
standby depending on
the signal level