Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FOOD FEEDING
Attention: Food is to be fed only when the machine is stopped. The knob for controlling speed must be set at
the "o" position.
Procedures
1. Turn the loading arm in the counterclockwise direction to remove the cover.
2. Pay attention to the two blades while feeding food into the container; Food should be cut into small blocks
before feeding. Warning: the food in the container is not allowed to exceed more than half of the total
volume of the bowl.
3. In case of accidents, the user should pay attention on his own position when using the machine. The user's
body should be vertical with the working table. The user must not hold down the machine or attempt to
prevent the machine from moving.
Do not get close to the machine and avoid touching the machine directly.
4. Put the cover in the start position, then rotate the loading arm until it locks.
5. Press the On/Off switch to "I".
6. Do not mix on low speed at an extended period.
7. While the machine is in operation, extra food should be fed through the hole on the cover if needed.
8. Press the red stop button if the food cutting is finished. If the mixer is equipped with speed adjusting knob,
then turn it to the "0" position and then stop the machine.
SHARPENING
Please sharpen the blades if the blades are not sharp enough to cut the food.
1. Turn off and unplug the machine.
2. Turn the loading arm to remove the cover.
3. Move the fixing axis of rotating blades away.
4. Use the sharpener from the manufacturer only. Sharpen the blade from the inside to outside along the
blade edge.
CLEANING
•
The machine should be cleaned at least once every day, more if necessary.
•
The parts that touch the food directly or indirectly must be cleaned thoroughly.
•
Water or high pressure spraying water cannot be used, as it will damage the machine. Brushes or other
tools which may damage the surface also cannot be used.
The following procedures should be done before cleaning and maintenance:
•
Turn off the power and unplug the unit.
Maintenance
7
Operation
Publicidad
Tabla de contenido
