Preparation Before Use; Setting Date/Time - Jacob Jensen 80 Manual Del Usuario

UK
d.

PrePArAtion before use

Attention
Your DECT phone is protected by PINs (personal identification numbers). Never change
the PINs of your base unit unless you are familiar with electronics products and you
have a real need to protect your phone by special PINs. A forgotten PIN could stop
operation of your DECT phone and may result in expensive technical support services.
For details please refer to section i. AdVAnced oPerAtion.
d.1. the ok/menu button
This DECT phone is built with a user-friendly MENU function. All essential functions of
this phone can be programmed via the MENU button
(Q&A) approach.
By pushing on the handset, it leads you to browse through the following
function menus in a circular manner. You may push
to browse downward.
Call Log List > Internal Call> Audio Setting >Display > Auto Talk > Time & Alarm > Add.
Settings > Setting Base > Baby Monitor >
Throughout the remaining part of this Instruction For Users, a quick Key Map will lead
you to different programming areas where you will be asked to make your selections.
d.2. changing language
English is factory-programmed display language. To change the language setting:
Display language on handset
Key Map:
display select lang.
1. Use / to browse through available languages
. When desired language is shown, push
38
by a question & answer
to browse upward and
Select your desired language
again to confirm.
d.3. setting date/time
Depending on country and telephone operator, usually every caller ID memory will be
stored with its incoming date and time information. It is not necessary to set the date/
time for use of this DECT phone in countries with FSK caller ID system as the date/time
information will be received automatically from the caller ID signal.
For use in countries with DTMF caller ID system (or countries with FSK system where
date/time is not sent from the telephone operator), go through the following
procedures to set date/time information:
Key Map:
time & Alarm set date & time
24 Hours mode
Use the numeric buttons on the handset to enter DATE information (MM/DD/YY
format), e.g. 060307 for 3rd June 007, push
(4:00 hours format). When finished, push
return to standby mode.
d.4. keypad lock
You may lock the keypad of your handset to avoid accidental operation. To lock the
keypad of your handset, give a long push on
When your keypad is locked, the keylock symbol will show on the screen. When the
keypad lock is on, you can still receive calls by pressing
To unlock your keypad, repeat the above procedure and the keypad will be unlocked.
d.5. Automatic call pick-up
Key Map:
Auto talk select on/off
Incoming call may be taken automatically when the handset is lifted from the base
unit. This is on condition that "Auto Talk" is set to "On". If the automatic call pick-up
is off, you have to press to answer a call, even if a handset is on the base or
charger. The default setting is "Off".
Press to return to standby mode.
date/time
again to enter TIME information
again to confirm. Press to
on your handset.
.