Operating Elements; Safety Notes - Monacor PA-120T Manual De Instrucciones

Please unfold page 3. Then you can always see the
operating elements and connections described.

1 Operating Elements

1 Indicating LED
lights up if a music cassette is played or is on fast
forward
extinguishes if the end of the cassette is reached
2 Button PLAY/FF/EJECT for the cassette player
a As soon as a music cassette is inserted into the
compartment (3), the button jumps out com-
pletely and the cassette is played.
b For fast forward, press in the button half-way
(locks into place).
c To eject the cassette, press in the button com-
pletely.
3 Cassette compartment
Insert the music cassette with the open side to the
right and with the blank tape spool pointing to the
rear.
4 Volume control AUX/TAPE for the cassette player
and for an audio unit connected to jacks AUX (15)
Note: Either operate the cassette player or the
connected unit. Otherwise both signals are
audible.
5 Volume control MIC 1 for a microphone connected
to jack MIC 1 (6)
6 6.3 mm jack (unbal.) MIC 1 to connect a micro-
phone
7 Volume control MIC 2 for a microphone connected
to jack MIC 2 (8)
8 6.3 mm jack (unbal.) MIC 2 to connect a second
microphone
9 POWER switch to switch on and off if the unit is
operated with 230 V~
10 Mounting bracket to fix the amplifier below a console
11 Mounting screws (4 x)
12 Mains cable for connection to a mains socket
(230 V~/50 Hz)
13 Fuse holder; a blown fuse must only be replaced
by one of the same type
14 Clamping screw for a possible ground connection
(e. g. for hum problems)
15 Phono input jacks AUX for the connection of an
audio unit with line output (e. g. tuner, CD player,
mixer, etc.)
16 12 V switch for switching on and off if the ampli-
fier is operated with 12 V
17 Screw terminals for operation with 12 V or emer-
gency power supply
18 Ground terminal for the speaker/s
19 Screw terminals for low impedance speakers
(impedance 4 Ω, 8 Ω, or 16 Ω)
20 Screw terminals for PA speakers which operate
with 100 V or 70 V technique
21 Protection cover for the screw terminals
The amplifier must not be operated without protec-
tion cover!

2 Safety Notes

This unit corresponds to the directive 89/336/EEC for
electromagnetic compatibility and to the low voltage
directive 73/23/EEC.
The unit is supplied with hazardous mains volt-
B
age (230 V~). Leave servicing to skilled person-
nel only. Inexpert handling may cause an elec-
tric shock hazard. Furthermore, any guarantee
claim will expire if the unit has been opened.
Caution! There is a hazard of contact at the
speaker terminals (20) with a dangerous volt-
age during operation.
All connections must only be made or changed
with the unit switched off.
It is essential to observe the following items:
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high hu-
midity, and heat (admissible ambient temperature
range 0 – 40 °C).
Do not place any vessels filled with liquid, e. g. drink-
ing glasses, on the unit.
The heat being generated in the monitor has to be
removed via air circulation. Therefore, the air vents
at the housing must not be covered with any objects.
Do not insert anything into the air vents! This could
result in an electric shock.
Do not set the unit into operation, and immediately
disconnect the mains plug from the mains socket if
1. there is visible damage to the unit or to the mains
cable,
2. a defect might have occurred after a drop or simi-
lar accident,
3. there are malfunctions.
The unit must in any case be repaired by skilled per-
sonnel.
A damaged mains cable must only be replaced by
the manufacturer or by authorized, skilled personnel.
Never pull the mains cable to disconnect the mains
plug from the mains socket.
For cleaning only use a dry, soft cloth, by no means
chemicals or water.
If the unit is used for purposes other than originally
intended, if it is not connected or operated correctly,
overloaded, or not repaired in an expert way, there is
no liability for possible damage.
If the unit is to be put out of operation definitively,
take it to a local recycling plant for disposal which is
not harmful to the environment.
Important for U. K. Customers!
The wires in this mains lead are coloured in accord-
ance with the following code:
green/yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug, pro-
ceed as follows:
1. The wire which is coloured green and yellow
must be connected to the terminal in the plug
which is marked with the letter E or by the earth
GB
7