Alarm; Wiring Diagram; Recycling; Warranty - Jotul F 262 Manual De Instrucciones

Fig. 9
30°C (start)
The fan will start automatically at 40% speed when the sensor
detects 30 °C, and it will stop when the sensor detects that the
temperature drops below 60 °C.
Changing the automatic settings:
The factory settings is 40% speed between 30 and 60 ° C. This
can be adjusted by doing the following:
«Auto/Manuell»
1. Press and hold
seconds. The display reads «SERVICE».
Choose between the different screens by pressing «On/
2.
Off» (Fig. 8 B).
• «FanAuto»: Press «Auto/Manuell». The value starts
flashing. The speed can now be adjusted between 20 %
and 60 % by pressing
to confirm.
• «TonAuto»: Press «Auto/Manuell». The value starts
flashing. The start temp. can now be adjustet between
20 °C and 40 °C by pressing
Manuell» to confirm.
• «ToffAuto»: Press «Auto/Manuell». The value starts
flashing. The stop temp. can now be adjustet between
50 °C and 80 °C by pressing
Manuell» to confirm.
The last screen reads «****» and indicates that the settings
3.
are saved.
Press «On/Off» to return to normal mode.
4.
If no buttons are pressed within 10 seconds, the control panel
will return to normal mode, and values that are not saved will
be deleted.

6.0 Alarm

An alarm is shown with a text on the display and with a sound.
The sound can be stopped with any key. The fan stops.
6.1 Alarm types
• «ALARM!! connect»: There is no contact between the modem
and the control unit. The fan will go for 30 seconds before
it automatically stops. If the connection is restored, and the
control unit was in manual mode, the fan will continue with
the same settings as it had before the contact was broken.
• «ALARM!! temp»: Damage to the sensor cable.
60°C (stopp)
Auto On
Manuell Off
+
(Fig. 8 A) for more than 2
«+» and «-». Press «Auto/Manuell»
«+» and «-». Press «Auto/
«+» and «-». Press «Auto/

7.0 Wiring diagram

L
Blower
N
230V/50Hz
PE
PE
PE
N
Mains
230V/50Hz L
Control panel

8.0 Recycling

8.1 Recycling packaging
The product is delivered with the following packaging:
• Cardboard packaging that should be taken to a local
recycling facility.
• Plastic bags that should be taken to a local recycling facility.
8.2 Recycling the product
Please return this product in your local recycling facility for
electronics and electrical equipment.

9.0 Warranty

The warranty does not cover:
The warranty is not valid for damage caused while the product
is in transit from the distributor to the delivery address. The
warranty is not valid either for damage caused by the use of
non-original parts.
ENGLISH
Temperature sensor
Temp.
RJ
RJ
21