Fermax MEMOKEY Manual De Instalador página 24

Enabling/Disabling the Exit Buttons (A5 - A6)
The system can be equipped with one or two buttons (P1 and P2) which are installed in the
interior of the building and allow you to open the door (relay activation) from inside or
activate an additional electronic device installed.
These buttons can be enabled or disabled in the following way:
Relay Timing:
- lock-release activation (A2)
- auxiliary device activation (A3)
Initially the relays (which will activate the lock-release or the auxiliary device) are set at 3
seconds.
The activation time can be changed to any value between 00 and 99 seconds or it can also
operate in bistable mode (the first valid code activates the relay and the next one deactivates
it):
Page 10
1 Enter programming mode:
2 Enter the relevant option:
A5: 1 Button. (Relay 1).
A6: 2 Button. (Relay 2)
3 Enter the associated action:
0: Button Disabled.
1: Button Enabled. Action, the door will open. (Relay 1)
2: Button Enabled. Action, the auxiliary device will be
activated (Relay 2)
(if exists).
3: Button Enabled. Action, the door will open and the auxiliary
device will be activated simultaneously.
Example:
Enable exit button 1 to open the door.
1 Enter programming mode:
2 Enter the relevant option:
A2 Relay 1 (lock-release)
A3: Relay 2 (additional electrical device
activation)
3 Enter the new activation code or
select bistable mode:
4 Enter 0 if the device is normally
deactivated.
Enter 1 if the device is normally
activated.
Example:
Change the relay timing to 5
seconds and normally deactivated.
NOTE: The most common case is that of normally deactivated devices such as normal
lock-releases for example.
normally activated devices.
Master Code (1480)
00:
01..99: (01 to 99 seconds)
The inversely operated lock-releases on the other hand are
Master Code
(1480)
A5 or A6
0, 1, 2 or 3
1480 A5 1
A2 or A3
Bistable Mode
0 or 1
1480 A2 05 1
beep (x3)
beep (x3)
beep (x3)
beep (x3)
beep (x3)
beep (x3)
beep (x3)