Attaching The Abrasive; Securing Polishing Attachments; Working With The Tool - Rotex RO 125 FEQ Manual De Instrucciones

Lijadora excéntrica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8 .1
the drive spindle is stationary. Do not switch on
the motor when the spindle stop is pressed in.
Simply press the abrasive onto the sanding pad
(7.2) and pull it off again after use.
Please note: Use only abrasives with an undam-
aged Stickfi x hook-and-loop coating. Before use,
check that the coating has not been damaged by
improper use (such as over heating).
To prevent damage, use PoliStick polishing at-
tachments (sponges, felt, lambswool bonnets)
only with the special polishing pad fi tted on the
tool instead of a sanding pad. Like StickFix abra-
sives, the PoliStick polishing attachments are
simply pressed onto the polishing pad and pulled
off after use.

Working with the tool

such a manner that it cannot move while being
8 .2
sanded.
too much pressure! The best sanding results
are achieved when applying moderate pressure.
Sanding performance and quality depend primar-
ily on the choice of the right abrasive.
For safe guidance, hold the tool with one hand on
the motor housing (8.2) and the other hand on the
gear head (8.1).
Tables A and B show the settings we recommend
for different sanding and polishing work.
9
Actuate the spindle stop only when

Attaching the abrasive

Stickfi x is a hook-and-loop fastening sys-
tem. Stickfi x sanding pads allow the use
of self-adhesive hook-and-loop abrasives
such as Stickfi x sandpapers and sanding
cloths.

Securing polishing attachments

Always secure the workpiece in
Never overload the tool by using

Publicidad

Tabla de contenido
loading

Tabla de contenido