Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
To reduce the risk of
injury, turn unit off and disconnect it
from power source before installing
and removing accessories, before
adjusting or when making repairs. An
accidental start-up can cause injury.
Laceration hazard.
Never remove the return springs (N)
Fig. 2.
If the springs are removed
the tool cannot be operated safely
because the blade will not retract
following a cut.
TO START AND STOP TOOL (FIG. 3)
Make sure switch is OFF and power circuit voltage is the same as
that shown on the specification plate.
1.
Connect tool to power circuit.
2.
Grip tool firmly to resist starting torque, and
squeeze trigger switch (E) to START tool.
3.
Release trigger switch to STOP tool.
4.
To lock the trigger switch in the "ON" position:
•
Squeeze trigger switch to START motor
and depress lock button (D), while
releasing trigger switch. Release lock
button.
•
To STOP tool, squeeze trigger switch
and release, while leaving lock button
free to spring out.
ADJUSTING DEPTH OF GROOVE (FIG. 4)
A "quick set" depth adjusting turret (H), provides
for quick changes in depth of cut to accommodate
the various sizes of available biscuits and other
accessories. To set depth of cut, rotate depth
adjusting turret until desired size marking on turret
aligns with the index mark (O). The following
depth settings are provided:
0
For "0" size accessories
10
For "10" size accessories
20
For "20" size accessories
MAX
For "6" size accessories,
provides maximum depth of
cut with 4" (101.6 mm) blade
FF
For PORTER-CABLE "FF" biscuits
Must use 2" (50.8 mm) blade
D
For "Duplex" accessories
S
For "Simplex" accessories
OPERATION
N
FIG. 2
FIG. 3
FIG. 4
8 8
D
E
O
H
Publicidad
Tabla de contenido
