Hitachi C 10RA2 Manual De Instrucciones página 13

4. Mounting and adjusting Saw Blade Guard Assembly
Down
Up
Tighten
Wheel
Fig. 9-a
6 × 110 mm Bolt
Guard Bracket
Fig. 9-b
Saw Blade
Straightedge
Fig. 9-c
Saw Less than Anti-kickback
Blade 1/2"(12.7 mm) pawl
Fig. 9-d
5. Mounting Table Insert
Table 5 mm Machine Screw
Fig. 10
CAUTION:
Saw Blade
Mount the saw blade guard assembly, which includes the
spreader and anti-kickback pawls (see Fig. 9-d).
Loosen
(1) Mounting the spreader
q Loosen the saw blade tilt lock handle, move the saw blade
Tilt Lock Handle
w Turn the wheel fully clockwise and set the saw blade to
Spreader
e Put a 6 mm spring washer and a D13 flat washer on to the
r Tentatively fasten the spreader on the rear section of the
6 × 90 mm Bolt
(2) Adjusting the spreader
q Use a straightedge to align the spreader with the saw blade
w Check clearance between saw blade tip and spreader.
Spreader
Spreader
6 × 16 mm
Bolt
Cusion
The table insert is mounted to the table with two 5mm machine
screws.
Table Insert
CAUTION:
The saw blade guard and spreader assembly
must be aligned properly to the saw blade in
order to prevent kickback.
tilting mechanism to the left and set the saw blade to 0° by
means of the stopper. Tighten the saw blade tilt lock handle
to lock it in position.
the maximum cutting height (see Fig. 9-a).
6 × 90 mm and 6 × 110 mm bolts.
body using the cusion and two 6 mm bolts mentioned
above (see Fig. 9-b and Fig. 9-d).
(The guard bracket must be attached to the spreader in
advance.)
(see Fig. 9-c).
Tighten the two 6 × 16 mm bolts (see Fig. 9-d) with a wrench
to lock the spreader.
It should be less than 1/2" (12.7 mm) at all positions. If not,
loosen the two 6 × 16 mm bolts securing the spreader to
the guard bracket with a wrench and move the spreader
up and down. After adjustment of the spreader is complete,
firmly retighten the two 6 × 16 mm bolts with a wrench
(see Fig. 9-d).
The table insert must be in place and securely
fastened at all times.
English
13