SEVERIN KS 9827 Instrucciones De Uso página 12

switching it on after it has been positioned.
- When the unit is first switched on, a slight 'new' smell may be noticed. However, this will
disappear once the cooling process has begun.
Installation
The appliance should be set up in a well-ventilated, dry room. It should be operated in an
ambient temperature of 16 to 32 °C and a relative humidity of max. 70 %. Do not expose the
appliance to direct sunlight, and do not position it next to any heat sources (radiators,
cookers etc).
- The rear and the sides should have a minimum clearance of 10 cm from the wall.
The unit must not be installed inside a cabinet, nor directly below a hanging cupboard,
shelf or similar object .
- Do not place any objects on top of the unit, and do not otherwise cover it.
If the floor is uneven, the adjustable foot can be used to compensate and ensure optimum
stability. The unit should be installed at a slight angle in such a way that it leans to the rear,
which will cause the door to close automatically so that it cannot be left open by mistake.
Ensure, however, that both front feet are set to the same height.
Ventilation
The heated air around the unit must be able to circulate freely. Therefore, ensure that the
circulation is not obstructed.
Reversible door
The design provides for the door to be reversed,
i.e. for right-hinged (default installation) to
become left-hinged.
1. Remove the upper hinge cover (1).
2. Use a suitable pointed tool to remove the cover
(5).
3. Use a screw-driver to remove the two screws
(2) holding the upper hinge to the right side of
the housing.
4. Carefully lift up the door and place it on a soft
surface to protect it from scratches.
5. Remove the blind cover for the hinge mounting
hole (9) and fit it in the corresponding place on
the right-hand side of the door. Ensure that the
cover is firmly pushed down into the hole.
6. Pull out the two bolts (7) which hold the lower right hinge plate (4) in position.
7. Remove the bolt on the left and insert it into the corresponding thread on the right.
8. Install the lower hinge plate on the left
9. Replace the door in its new position. Ensure that the hinge pin is inserted into the guide
bushing (hole) on the lower part.
10. Install the upper hinge (3) on the left-hand side, using the screws (2). Ensure that the
hinge pin is inserted into the guide bushing (hole) on the upper part.
11. Replace the cover (5) in the corresponding holes on the right.
12. Replace the hinge cover (1) on the upper hinge.
12