Dometic Cup Cooler Instrucciones De Montaje página 10

Installation
➤ Lower the upper ring down on the lower body by aligning the pin into the
slot between the two LED lights (3).
➤ Turn the ring counter-clockwise until it stops (4). It only fits one way.
➤ Make sure the can pusher insert is properly aligned in bottom of Cup
Cooler with the two pushers on the same side as the two LED lights
(fig. 2 1, page 3).
➤ Tighten the three support screws until they make contact with the under-
side of the mounting surface (5).
➤ Connect a 10 mm drainage hose to the drain tube fitting on the bottom of
the unit (6).
➤ Route the output sloping downward to an appropriate drainage location
onboard.
5.3 Electrical connections (12 Volt DC only)
I
NOTE
 Control of Cup Cooler can be managed with a single switch or
set up with zone switching.
 Low-voltage cut off is at 10.5 volts DC to avoid a dead battery.
➤ Locate (or install) an auxiliary 12 V DC power switch (not included in
scope of delivery).
Typically this will be on a fused branch circuit attached to the supply bat-
tery (not the engine battery).
➤ With the power off, attach the wires of the Cup Cooler to the wiring of that
switch. The red wire is positive and the black wire is negative.
Each unit has a 5 amp fuse built into its wiring which should be posi-
tioned in an accessible location (fig. 1 1, page 3).
➤ Power on the switch and verify the blue lights inside the Cup Cooler are lit.
10
Cup Cooler
EN