Battery Replacement; Updating The Firmware; Maintenance Of The Unit - IMG STAGELINE CD-196USB Manual De Instrucciones

6.1 Battery replacement

If the range of the remote control decreases, the
battery must be replaced.
1) Press the locking of the battery support to the
left (1 st arrow in fig. 8) and at the same time
remove the support downwards (2
Fig. 8 Battery replacement
2) Remove the old battery and insert a new one
(3 V button cell, type CR 2025). Ensure that
the positive pole of the battery shows
upwards in the support.
3) Slide back the support into the remote con-
trol.
Do not put exhausted batteries into the
household rubbish but take them to a
special waste disposal (e. g. collective
container at your retailer).

7 Updating the Firmware

If a new firmware (operating system of the unit)
is available on the Internet, the firmware of your
unit may be updated:
1) If a firmware update for the CD-196USB is
offered on the home page of "img Stage Line"
(www.imgstageline.com),
copy it onto a USB memory stick.
2) Switch off the CD / MP3 player with the power
switch (12).
3) Insert the USB memory stick with the new
firmware version into the USB port (2).
4) Keep the button PROG. (7) pressed and
switch on the unit again. Do not release the
button PROG. until "UP dA t E" is shown on
the display.
5) After reading in, when "Ready" appears in the
text line (N), press the button
the firmware update. By means of the bar
graph indication (H) and the text line the
update can be observed. When "Finish" is
shown, the firmware has been updated.
6) Switch off the player and switch it on again.
Attention: The firmware update is made at your
own risk. After the update the way of functioning
of the unit may be different from that described in
this manual.

8 Maintenance of the Unit

Protect the unit from dust, vibrations, humidity
and heat (admissible ambient temperature
range 0 – 40 °C). For cleaning only use a dry,
soft cloth, never use water or chemicals.
Note concerning sound interruptions and
reading errors
Cigarette smoke and dust will easily penetrate
through all openings of the unit and also settle on
the optics of the laser sampling system. If this
deposit should cause reading errors and sound
interruptions, the unit must be cleaned by skilled
personnel. This cleaning will be charged, even
during the warranty period!
All rights reserved by MONACOR
manual may be reproduced in any form or by any means for any commercial use.
9 Specifications
Frequency range: . . . . . 20 – 20 000 Hz
THD: . . . . . . . . . . . . . . . < 0.1 %
Channel separation: . . . > 75 dB
Dynamic range: . . . . . . > 80 dB
nd arrow).
S / N ratio: . . . . . . . . . . . > 75 dB
Outputs
LINE OUT: . . . . . . . . 2 V
DIGITAL OUT: . . . . . 0.5 Vpp S / PDIF
USB standard: . . . . . . . 2.0
Readable file systems: . NTFS, FAT, HFS+
Max. number of
partitions: . . . . . . . . . 16
folders: . . . . . . . . . . . 999 per partition,
MP3 files: . . . . . . . . . 999 per folder
Anti-shock memory
standard audio CDs: . 8 s
MP3 files: . . . . . . . . . 10 s
Power supply: . . . . . . . . 230 V~ / 50 Hz
Power consumption: . . . 15 VA
Ambient temperature: . . 0 – 40 °C
Dimensions: . . . . . . . . . 482 × 90 × 270 mm
Weight: . . . . . . . . . . . . . 4.4 kg
Connections
USB input: . . . . . . . . type A
download and
analog output: . . . . . . phono Left / Right
digital output: . . . . . . phono
fader start: . . . . . . . . 3.5 mm connector
Subject to technical modification.
(19) to start
® INTERNATIONAL GmbH & Co. KG. No part of this instruction
in 8 levels max.
(W × H × D),
2 rack spaces
GB
15