Prilux SILENT LED I Instrucciones De Montaje página 5

SILENT LED I
600
WARNING
BEFORE INSTALLING THIS PRODUCT, PLEASE READ THE
INSTRUCTIONS CAREFULLY AND STORE THEM IN A
SAFE PLACE.
THE INSTALLATION SHOULD BE CARRIED OUT BY
TRAINED STAFF.
INCORRECT HANDLING OF THE PARTS OR THE
LIGHT FIXTURE ITSELF MAY IMPAIR THE PROPER
PERFORMANCE OF THIS PRODUCT. IN THIS CASE,
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID.
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID: IF THE INSTALLATION IS NOT PERFORMED IN
ACCORDANCE WITH THE SPANISH LOW VOLTAGE
ELECTROTECHNICAL REGULATION 2002 (REBT 2002).
THE APPLICATION OF IBC BT09-4 OF REBT (INSTALLATION
OF LINE AND LIGHT FIXTURE SURGE PROTECTORS) IS
ESSENTIAL FOR INDUSTRIAL AND PUBLIC LIGHTING
INSTALLATIONS. THE GUARANTEE DOES NOT COVER
AGAINST DAMAGES CAUSED BY SURGES IN LIGHT
FIXTURES WITHOUT SURGE PROTECTORS INSTALLED.
ATTENTION!!!
OBSERVE PRECAUTIONS
HANDLING
SENSITIVE DEVICES.
1/4
octubre 2019
10,5
FOR
ELECTROSTATIC
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
300
PRECAUTIONS:
• Read this manual before installing the product, if in doubt consult qualified
personnel
• If the product or diffuser is damaged, replace it immediately with a new
one
• Disconnect the power before installing the product
• Keep the product out of the reach of young children.
• Do not handle the product while it is in operation and let it cool before
touching it with your hands.
• Do not install the product where there are heat sources or moisture con-
centrations.
• This device must be used with the specified power supply
• Not valid for use in bathrooms.
• Only for interior use.
• LED lamp not replaceable.
ASSEMBLY INSTRUCTIONS:
1. Disconnect power.
2. Connect the power cables. Make sure the connection is correct and
there is no bare copper wire.
3. Connect the power and control cables according to the connection
diagrams Fig. 5. Caution: Ensure correct polarity.
4. Mount the device and the power supply in the appropriate position,
respectively.
5. Turn on the power again.
SURFACE MODEL:
Surface mounting accessory consisting of a steel sheet drawer provided with
two recordable sides for luminaire insertion.
INSTALLATION:
1. Remove one of the side covers of the drawer (FIG. 1).
2. Proceed to stake out the fixing points.
3. Make the holes.
4. Proceed to anchor the drawer to the surface by means of the correspon-
ding fixings by previously passing the power cable through the hole
10,5 600