Using The Drying Rack; Additional Features - Sears Kenmore 110.6163610 Serie Manual De Uso

Changing the Sensing Cycle settings
to increase or decrease drying time
If all your loads on all Automatic Cycles are consistently less dry
or more dry than you would like, you may change the default
settings to increase or decrease the default dryness level.
Your automatic drying settings can be adjusted to adapt to
5 drying settings, which are displayed using the time display:
0 Much wetter clothes, 30% less drying time
1 Slightly wetter clothes, 15% less drying time
2
3 Slightly drier clothes, 15% more drying time
4 Much drier clothes, 30% more drying time
To change the drying settings:
NOTE: The settings cannot be changed while the dryer
is running or paused. The dryer must be in standby mode
(power is ) to adjust the default settings.
1.
for 3 seconds.
2. Touch DRY LEVEL to select the dryness level shown in the
time display: 0, 1, 2, 3, or 4.
3.

ADDITIONAL FEATURES

Using the Drying Rack

To obtain a drying rack for your dryer, order by calling
1-844-553-6667 (U.S.A.) or 1-800-469-4663 (Canada).
You will need your model and serial number and the
purchase date. Remove and discard any packing material
before use.
Use the Drying Rack for items that you do not want to tumble
dry, such as sweaters and tennis shoes. When you use the
drying rack, the drum continues to turn, but the rack remains
stationary.
The drying rack is intended for use with the Timed Cycles
Cycles.
To use the drying rack:
IMPORTANT: Do not remove the lint screen.
1.
10
Using the Drying Rack
2. Align the two hooks on the front of the drying rack with the
holes in the dryer door opening and press down fully into
holes. Rest the rear support on the dryer back ledge.
3. Place wet items on top of the drying rack. Allow space
around items for air to circulate. The drying rack does not
move, but the drum will rotate; be sure to leave adequate
clearance between items and the inside of the dryer drum.
Make sure items do not hang over the edges or between
drying rack grille.
4. Close the door.
5.
Items containing foam, rubber, or plastic must be dried
6. When the cycle is selected, the Estimated Time Remaining
display shows the default time. You can change the actual
time in the cycle by increasing or decreasing the cycle time.
7. Start the dryer.
NOTE: Check the lint screen and remove any lint accumulated
(cont.)