Unitekno C200A Instrucciones De Uso Y Mantenimiento página 16

WARNING!
Do not use this machine if there are signs
of damage (cracks, breaks), if the power
cord is damaged, or if you suspect that
there may be an internal defect (for
example, after the machine has fallen).
If the power cord is damaged, a
manufacturer-authorised service centre
must replace it since a special tool is
needed to access it.
Read the rating-plate located under the
machine; make sure the voltage and input
ratings comply with the system' s capacity.
Plug the machine into a grounded outlet.
While moving the machine, avoid tugging
on the power cord.
Disconnect the machine from the
electrical power source by pulling the
plug. Do not disconnect it by pulling on
the cord, since this could damage the
machine.
Do not leave the machine unattended
while it is plugged in.
Do not let children or other incompetent
persons use the machine.
Do not attach devices that exceed the
indicated input rating to the machine!
Only use the machine' s original
accessories, which are guaranteed
compatible by the manufacturer.
This machine has been manufactured for
use in enclosed (covered) areas.
Do not submerge the machine in water!
Do not open the boiler valve cap while
under pressure.
Do not point the steam jet at
persons or other living beings.
This machine produces high-
temperature steam. Avoid direct contact
with the skin.
ATTENTION! Danger of burning.
Vapor must never be directed toward
equipment containing electrical parts,
like the inside of ovens.
Do not place any type of substance
(detergents or anything else) in the boiler
if not specifically approved by the
manufacturer.
Before using the machine to clean
surfaces that may get damaged (e.g.
synthetic fibres, plastics, wood, etc.),
check their capacity to withstand high
temperatures by doing a trial run on a
hidden area and by carefully following
manufacturer' s instructions.
Only use original replacement parts for
any necessary repairs. Please see an
authorised service centre.
Disconnect the equipment from the
electrical system before proceeding
with cleaning or maintenance
operations.
The aperture for cleaning the boiler must
not be open during use.
15