Fixing and moving
1. The refrigerator should be laid at solid level place. The two fronts should be adjusted to make the
refrigerator stable. The legs should be fully contacted with the ground to avoid vibration and noise.
2. Do not place the refrigerator near a heat source or expose it to direct sunlight. If the refrigerator is
placed near a heat source an insulation plate must be used and the following minimum distance
between the refrigerator and the source of heat must be observed:
-30cm from another electrical appliance not used for cooking
-30cm from a stove or other cooking facility
3. The refrigerator should be placed in a dry and well-ventilated room. A distance of over 100mm from
wall, 300mm from the top and 200mm from both sides of the refrigerator should be kept for proper air
circulation. The ventilation inlet and outlet grills and other airways must never be covered. And a
clear space should be left to open its doors to 160
4. When fixing refrigerator, the foaming package should be cancelled. (Including the foaming bottom)
5. When moved, the refrigerator cannot be declined to bigger than 45
Cleaning and maintaioning
The refrigerator should be cleaned once a month.
1. Before cleaning, disconnect the refrigerator from the power supply.
2. Whilst cleaning do not allow water to get into the inside light.
3. Wipe the inner and outer surface of the refrigerator and its accessories with wet cloth. If they are too
o
. (As chart)
o
or upside down. (As chart)
P-7