Safe Operation; Installation And Connection - Pontec PondoSolar 250 Control Instrucciones De Uso

- EN -

Safe operation

 Do not carry or pull the unit by its electrical cable.
 Route cables/hoses such that they are protected from damage and do not present a tripping hazard.
 Only use original spare parts and accessories for the unit.
 In the case of electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the wa-
ter: Isolate the units and installations (switch off and disconnect from the power supply) before reaching into the wa-
ter.
 Only operate the pump together with the supplied solar module.
 Do not allow the pump to run dry.
 Protect the unit from knocks or vibration.
 Clean the unit at least twice a year.
 Keep the connection plugs dry.

Installation and connection

How to proceed:
 B
1. Fit the transition piece onto the pump.
2. Assemble the nozzle unit and the LED lighting and fit onto the pump.
– Adapt the number of nozzle extensions used to the depth of the pond.
3. Connect the connection cables of the pump and LED lighting to the solar module. (→ Commissioning/start-up)
– Push each plug into the socket as far as possible to ensure that the connection is watertight.
4. Assemble the ground stake set and attach it to the solar module.
– Align the solar module such that the sockets with the connection cables point downwards.
5. Install the solar module so that it is exposed to direct sunlight.
– Recommendation: Align the solar module to the sun to ensure maximum energy yield.
6. Fix the pump underwater to a smooth, clean surface using the suction cups.
10