Cleaning And Disinfection; Safety Information For Reprocessing; Reprocessing Procedure - Dräger 8413417 Instrucciones De Uso

Fault
For standby devices:
Compressor starts up although
pressure in the central gas
supply system is over
2.7 bar (40 psi)
±0.2 ±3

Cleaning and disinfection

Safety information for reprocessing

WARNING
Validated processes must be used to clean
and disinfect the device and accessories. Risk
of equipment damage or personal injury!

Reprocessing procedure

Classification of medical devices
For reprocessing, medical devices are classified by
application type and the resulting risk:
– Non-critical medical devices: Surfaces
accessible to the user, e.g., compressor, cable
Cleaning and disinfection procedures
The following cleaning and disinfection procedures
are available:
– Manual cleaning and disinfection
Observe the manufacturer's information for the
cleaning and disinfection procedures.
First clean and then disinfect.
Disinfectants
Refer to the country-specific listings for the
disinfectants. The list of the Association for Applied
Hygiene (VAH list) applies for the German-
speaking region.
Instructions for Use Air Compressor
Cause
Pressure switch defective
The composition of the disinfectant is the
responsibility of the manufacturer and can change
over time.
Observe the manufacturer's information for the
disinfectants.
Testing of procedures and agents
The cleaning and disinfection of medical devices
was tested using the following procedures and
agents. At the time of testing, the agent
Buraton 10F from Schülke & Mayr exhibited good
material compatibility and effectiveness.
Manual cleaning and disinfection
Active
ingredients
Performing manual cleaning
 Use a moist cloth to remove any soiling.
English / US English
Remedy
Call DrägerService
Non-critical medical devices
Manual Manual
cleaning disinfection
Mildly alkaline Aldehydes or
or enzymatic quaternary
cleaning agents ammonium
compounds
29