Viewing The Connections - Side Connectors; Power Connection - Nevir NVR-7502-19HDD-N Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Note: If an external device is connected via the SCART socket, the TV will automatically switch to AV mode.
Note: S-VHS signal is supported via the scart socket (optional).
Note: When receiving DTV channels (Mpeg4 H.264) or while in Media Browser mode, output will not
be available via the scart socket.
4.
VGA Input
is for connecting a personal computer to the TV set.
Connect the PC cable between the PC INPUT on the TV and the PC output on your PC.
Note: You can use YPbPr to VGA cable (not supplied) to enable YPbPr signal via VGA input.
WARNING: You cannot use VGA and YPbPr at the same time.
5.
SPDIF Out
outputs audio signals of the currently watched source.
Use an SPDIF cable to trasfer audio signals to a device that has SPDIF input.
6.
DC 12 V Input
is used for connecting the supplied power adaptor.

Viewing the Connections - Side Connectors

1.
CI Slot is used for inserting a CI card. A CI card allows you to view all the channels that you subscribe
to. For more information, see "Conditional Access" section.
2.
Side USB input.
Note that programme recording feature is available via this USB input. You can
connect external hard disk drives to this input.
3.
Side audio-video connection
of external devices. To make a video connection, you must use the supplied AV
connection cable for enabling connection. First, plug singular jack of the cable to the
TV's Side AV socket. Afterwards, insert your video cable's (not supplied) connector into
the YELLOW input (located on the plural side) of the supplied AV connection cable.
Colours of the connected jacks should match.
To enable audio connection, you must use RED and WHITE inputs of the side AV
connection cable. Afterwards, insert your device's audio cable's connectors into
the RED and WHITE jack of the supplied side AV connection cable. Colours of the
connected jacks should match.
Note: You should use audio inputs of side AV connection cable (RED & WHITE)
to enable sound connection when connecting a device to your TV by using PC or
COMPONENT VIDEO input.
4.
Headphone jack is used for connecting an external headphone to the system. Connect
to the HEADPHONE jack to listen to the TV from headphones (optional).
5.
Volume/ Programme/ Source and Standby-On switch).

Power Connection

IMPORTANT: The TV set is designed to operate on 12 V DC. For this, an adaptor is used which gives
12 V voltage. Connect this adaptor to a system that supplies 110-240V AC,50/60Hz.
After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the
mains.
input is used for connecting video and audio signals
To POWER
INPUT DC 12 V
terminal
AC adapter
English - 9 -
V+
V+
.
V-
V-

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Nvr-7502-19hdd-b

Tabla de contenido