Control Panel; Making Ice; Cleaning, Care & Maintenance - Polar T315 Manual De Instrucciones

UK
Operation

Control Panel

Hand button Ice cube size indicator
Power switch: This switch can control the
mains power supply of the appliance.

Making Ice

Note: Before using for the first time, clean
the water tank, ice basket and ice basket
shelf. Use the first 3 ice making cycle to
flush out the system. Discard the water and
ice created from the first 3 cycles.
Each time the appliance is refilled, the first
ice making cycle is used to reduce the water
temperature. This results in uneven ice cube
production which is perfectly normal. You may wish
to discard ice created in the first two production
cycles.
4
T315_ML_A5_v9_20200716.indb 4 T315_ML_A5_v9_20200716.indb 4
1. Lift the access lid and fill the water tank up the
level of the ice basket shelf.
2. Connect the appliance to the power and press
the START button.
3. Press the HAND button repeatedly to scroll
through the ice cube sizes. Stop when the
required size is illuminated.
Note: The ice making cycle takes between
6-12 minutes, depending on the size of
cube selected. Larger cubes will take longer
to produce.
4. The appliance will run a startup routine and
then begin ice production.
Note: If the water level is too low, the
Water Low indicator lights up and the
appliance stops working. Fill the water tank
and the appliance will restart automatically.
5. When the cubes reach the ice sensor the
appliance will stop production. Production
resumes once ice has been removed.
6. Press the STOP button at any time to halt the
ice making process.
Cleaning, Care &
Maintenance
• Always switch off and disconnect the power
supply before cleaning.
• Warm, soapy water is recommended for
cleaning. Cleaning agents may leave harmful
residues. DO NOT wash the base unit, instead
wipe the exterior with a damp cloth.
• A POLAR agent or qualified technician should
carry out repairs if required.
• Clean the water filter regularly with a small
brush, particularly in hard water areas. The
water filter is located in the pump inlet at the
bottom of the water tank, remove by pulling
out with fingers.
2020/7/16 16:14 2020/7/16 16:14