LD Systems LDDPA260 Manual De Usuario página 6

9
OUTPUT METER 1 - 6
7-Segment LED level meter for the output channels 1 to 6. To avoid distortion, reduce the volume level of the corresponding output channel
as soon as the red CLIP LED lights up. The yellow LIMIT LED lights up when the output signal of the corresponding channel is limited by the
integrated limiter (limiter settings according to the system components).
10
EDIT-LED
Press button 12 of the desired input or output channel briefly to enter the edit mode of the channel. The blue EDIT LED of the selected
channel lights up. In order to exit the edit mode of the respective channel, briefly press button 12 again. The blue EDIT LED is extinguished.
11
MUTE-LED
Press button 12 of the desired input or output channel for about 2 seconds to mute the channel. The red MUTE LED of the selected channel
lights up. In order to switch off the mute feature of the respective channel, press button 12 again, for about 2 seconds The audio signal is
played back again and the red MUTE LED is extinguished.
12
FEATURE SWITCH INPUT A / B AND OUTPUT 1 - 6
Press the switch to access the features described in paragraphs 10 and 11.
13
USB-PORT
The USB-port is used to comfortably edit and manage all functions or presets of the LDDPA260 DSP controller on a Windows PC. Software
and drivers for Windows operating systems are enclosed with the unit, but can also be downloaded from our website WWW.LD-SYSTEMS.
COM, as well as presets for a wide range of LD Systems speakers.
14
ON
On / Off switch for the power supply of the device.
15
IEC POWER SOCKET WITH INTEGRAL FUSE HOLDER
Used to power the device. An appropriate power cord is included in the delivery. IMPORTANT INFORMATION: Replace the fuse only with a
fuse of the same type and rating (T800mAL/250V)! If the fuse blows repeatedly, please contact an authorised service centre.
16
GROUND LIFT
Can eliminate ground loop hum if devices with varying ground potentials are connected.
17
RS485 IN
In conjunction with the USB to RS485 adapter LDDPA260RC, this interface enables the remote control of the LDDPA260 via a conventional
XLR-multi-core through a Windows-based computer on the mixer
18
RS485 OUT
Is used to route the control signal to one or more additional LDDPA260 DSP controllers.
19
S/PDIF
Digital stereo input in coaxial S/PDIF format.
20
OUTPUTS 1 - 6
Balanced audio inputs with 3-pin male XLR sockets.
21
INPUTS A + B
Balanced audio inputs with 3-pin female XLR sockets.
6