JB Systems DMX 400 Manual De Instrucciones página 5

OPERATING INSTRUCTIONS
1. Turn on the power switch.
2. Press mode select to select the desired mode.
Hold dimmer: channel output is controlled by channel
dimmer control and master control. Corresponding Led is
lighting.
Hold sound: corresponding Led is lighting. Channel output is
controlled by channel control and the music sensitivity is
adjusted by the Audio Level control.
Prog sound: you can select the desired program from 42
preset programs using the Prog select button. The chasing
speed is controlled by the music.
Prog speed: corresponding Led is lighting. The same as Prog
sound but the chasing speed is controlled by Speed control
fader or Tap sync.
Auto speed: operation according to Prog speed. In this mode
each program will be executed four times before moving auto-
matically to the next program.
Auto sound: same as Auto speed, each program will be exe-
cuted four times. The chasing speed is controlled by the music.
Memory: you can choose between Program (PR), manual
(ST), auto sound (AS) and auto speed (AP). Hold the Program
select button, press the stand by button once. Your choice will
be shown on the display. To select the next mode, press stand
by once more. To run the selected mode, press Prog select.
PR mode: press Prog select until 01 appears on the display.
•
Adjust the master dimmer control or channel dimmer control
as you wish. Press the prog select button. The display will
blink 4 times, which means the step is programmed in the
memory. 02 will appear on the display. Repeat the former
actions until step 32 and exit the PR mode. If you fail in a
certain step, you should restart programming.
ST mode: press prog select once, program will execute one
•
step. The information will be shown on the display.
5 DMX 400