Sunbeam STEAM MASTER LX Manual De Instrucciones página 8

Maintenance
Other than the recommended instructions in this pamphlet, no further maintenance is necessary.
However, following is a list of frequently asked questions and their resolutions. If for any reason
your iron continues to exhibit one of these symptoms, or requires repair for another reason, send
it to the Sunbeam Appliance Service Center or call our Consumer Hot Line 1-800-597-5978.
SYMPTOM
Iron emits an odor
Iron does not heat
Iron does not steam
SHOT OF STEAM
does not work
SPRAY MIST feature
®
does not work
Iron is leaking
Cord will not pull out
Cord does not retract
RESOLUTION
• Iron gives off an odor when turned on for the first time.
Allow ten minutes for odor to disappear.
• Iron should be plugged into a 120 volt, AC electrical
outlet only.
• The temperature dial must be set at the desired temperature.
• The auto shut-off feature may have been activated (Some Models
Only). Move the iron back and forth to restart.
• The water tank may be empty. Turn steam valve to DRY
and add water.
• Allow iron to heat, then set the steam dial to one of the steam
settings. Use temperature settings within the steam band.
• There may be an obstruction. Remove steam valve by turning
it to CLEAN. Replace and set the steam dial to one of the
steam settings.
feature • The water tank must be at least 1/4 full.
®
• Temperature must be set to steam position.
• Iron should be in the horizontal position.
• Prime pump briefly.
• Allow a short pause between shots.
• Be sure to fully depress the SHOT OF STEAM
• The water tank must be at least 1/4 full.
• The variable steam dial must be set on DRY until the iron is hot
• The temperature setting is too low to produce steam
(See Ironing Guide)
• Pull cord firmly to unwind.
• Press winding button to reset device, then pull cord.
• Pull out the cord once and wind cord evenly on the reel.
9
button.
®