Troubleshooting - EINHELL GE-LC 36/35 Li - Solo Manual De Instrucciones Original

Motosierra de batería
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 137

11. Troubleshooting

Danger!
Before troubleshooting, switch off the equipment and pull out the battery.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if
your tool fails to work properly. If the problem still persists after working through the list then please con-
tact your nearest service workshop.
Cause
Chainsaw does not
work at all
Chainsaw operates
intermittently
Saw chain dry
Chain brake does
not work
Chain/guide rail hot
Chainsaw judde-
ring, vibrating or not
sawing properly
Anl_GE_LC_36_35_Li_Solo_SPK9.indb 32
Anl_GE_LC_36_35_Li_Solo_SPK9.indb 32
GB
Fault
- Quick stop brake (chain brake) trip-
ped
- No power supply
- Loose connection (external)
- Loose connection (internal)
- ON/OFF switch defective
- No oil in the tank
- Oil tank cap breather blocked
- Oil outlet blocked
- Problem with the switch mecha-
nism in the front hand guard
- No oil in the tank
- Oil tank cap breather blocked
- Oil outlet blocked
- Blunt chain
- Chain tension too loose
- Blunt chain
- Worn chain
- Saw teeth pointing in the wrong
direction
- 32 -
Remedy
- Pull the hand protection back to the
normal position.
- Check the power supply.
- Consult a specialist workshop.
- Consult a specialist workshop.
- Consult a specialist workshop.
- Fill up with oil.
- Clean the oil tank cap.
- Clear the oil outlet.
- Consult a specialist workshop.
- Fill up with oil.
- Clean the oil tank cap.
- Clear the oil outlet
- Re-sharpen or replace the chain.
- Adjust the chain tension.
- Re-sharpen or replace the chain.
- Replace the chain.
- Reinstall the saw chain with the
teeth facing in the correct direction.
08.05.2018 09:50:37
08.05.2018 09:50:37

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

45.017.80Ge-lc 35 li - soloGe-lc 36 li - solo

Tabla de contenido