Defects And Malfunctions; Bluetooth & App; Cleaning And Maintenance; Transport And Storage - Tunturi FitCycle 90i PRO Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 75
Body Fat
- Press the BODY FAT key to start body fat
measurement.
- During measuring, users have to hold both
hands on the hand grips. LCD display "-" "- -"
"- - -" "- - - -" for 8 seconds until computer
finish measuring.
- LCD will display BMI and FAT %.
Body fat mode error codes
- *E-1
There is no heart rate signal input detected.
- *E-4
Occurs when FAT% and BMI result is below 5 or
exceeds 50.
Bluetooth & APP
- This console can connect with an APP on a
smart device by Bluetooth (iOS & Android).
- Establish the Bluetooth connection only via the
connection mode on the installed APP on your
smart device.
- When the bluetooth connection between APP
and console is establisched the console display
will be dimmed.
NOTE
Tunturi only provides the option to
connect your fintess console throughout a
blue tooth connection. Therefore Tunturi
cannot be held resposible for damage,
or malfunctioning of products other than
Tunturi products.
Check the website for extra information.

Cleaning and maintenance

The equipment does not require special
maintenance. The equipment does not require
recalibration when it is assembled, used and
serviced according to the instructions.
WARNING
Do not use solvents to clean the equipment.
- Clean the equipment with a soft, absorbent
cloth after each use.
- Regularly check that all screws and nuts
are tight.
- If necessary, lubricate the joints.

Defects and malfunctions

Despite continuous quality control, defects and
malfunctions caused by individual components
may occur in the equipment. In most cases it's
unnecessary to take the whole device in for repair,
as it's usually sufficient to replace the defective
part.
If the equipment does not function properly
during use, contact your Tunturi dealer
immediately. Always give the model and serial
number of your equipment. Please state also
the nature of the problem, conditions of use and
purchase date.
If you require spare parts, always give the model,
serial number of your equipment and the spare
part number for the part you need. The spare part
list is at the back of this manual. Use only spare
parts mentioned in the spare part list.
Trouble shooting:
- If there is no signal when you pedal, please
check if the cable is well connected.
NOTE
When stop training for 4 minutes, the main
screen will be off.
If the computer displays abnormally, please
re-install the transformer and try again.

Transport and storage

WARNING
Before transport and storage, remove the
adapter.
Carry and move the equipment with at least
two persons.
- Remain standing in front of the equipment
on each side and take a sturdy grip at the
handlebars. Tilt the front of the equipment
so as to lift the rear of the equipment on the
wheels. Move the equipment and carefully put
the equipment down. Place the equipment on a
protective base to prevent damage to the floor
surface.
- Move the equipment carefully over uneven
surfaces. Do not move the equipment upstairs
using the wheels, but carry the equipment by
the handlebars.
English
27

Publicidad

Tabla de contenido
loading

Tabla de contenido