Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
•
Make sure your hands are dry before you touch
the appliance.
•
Unplug the appliance before assembling
or disassembling it and before cleaning or
servicing the unit.
•
Engine driven appliances: beware of sharp
and/or moving parts. Always keep your hands
away from the moving parts when using,
cleaning or servicing the appliance.
•
Heating devices: wait until the appliance has
cooled down before you touch the housing and
parts of the unit.
Be extra careful during cleaning and servicing.
DESCRIPTION (FIG. A, P.2)
Your BOURGINI juicer has been designed
for rapidly pressing citrus fruits. The appliance
is suitable for domestic use only.
1. Pressing cone
2. Pulp collector
3. Juice collector
4. Motor housing with lever
5. Juicer cone cup
6. Spout with drip stop
7. Leaking plate
INITIAL USE
Preparation
•
Clean the appliance. Refer to the section
"Cleaning and maintenance".
ASSEMBLY (FIG. A)
Warning!
•
Before assembly, remove the mains plug
from the wall socket and wait for the motor
to stop running.
•
Place the juice collector (3) onto the motor
housing (4).
•
Place the pulp collector (2) onto the juice
collector (3)
•
Place the pressing cone (1) onto the
pulp collector (2).
USE
WARNING!
•
Do not use the appliance without the juice
catcher (3), the juice may then penetrate the
motor.
•
Never leave the appliance on continuously for
more than three minutes.
•
Let the appliance cool down for about five
minutes after every ten press sessions.
•
Assemble the citrus press. See the section titled
"Assembly".
•
Cut the citrus fruit in half.
•
Place the cut part of one half in the juicer head
or on the press cone.
•
Place a glass under the spout.
•
Push the spout downwards to open it. Push the
spout upwards to close it (drip stop).
•
Press the citrus fruit with the handle. The appliance
will automatically begin to press the citrus fruit.
The juice will automatically flow into the glass.
•
The "wings" on the sides of the press cone
spread the pulp across the pulp guard so that
the filter will not clog.
•
When there is a lot of pulp on the pulp guard,
clean it in order to prevent clogging.
•
Press the citrus fruit until hardly any juice
comes out of it. The appliance will automatically
stop when pressure is no longer applied.
Note: The appliance will automatically change
directions when turned on/off to ensure that more
juice is released.
•
Stop pressing the citrus fruit in one of the
following situations:
- No more juice is coming out of the citrus fruit
- The glass is filled with the desired amount of
juice.
•
After use, remove the mains plug from the wall
socket.
CLEANING AND MAINTENANCE
The appliance must be cleaned after each use.
Warning!
•
Before cleaning or maintenance, remove
the mains plug from the wall socket and
wait for the motor to stop running.
•
Do not immerse the appliance in water or
other liquids.
Caution!
•
Do not use aggressive or abrasive cleaning
agents to clean the appliance.
•
Do not use sharp objects to clean the appliance.
•
Do not clean the appliance in the dishwasher.
It is not recommended to wash the removable
parts of the appliance or the accessories in a
dishwasher.
•
Regularly check the appliance for possible damage.
•
Clean the motor housing with a soft, damp cloth.
•
Clean the accessories:
- Clean the pressing cone, the pulp collector and
the juice collector in soapy water.
8
Publicidad
Tabla de contenido
