QUICK START GUIDE
SOLUTION OR WASHING WATER TANK
FILLING
1.
Open the water inlet cover (B, Figure 7).
2.
Filling water or solution suitable for work performance
through the water inlet with filter.
The solution temperature must not exceed +104F (+40°C).
3.
Do not overfill the tank, refer to water level indicator (H) for
the water volume.
WARNING!
Use only low-foam and non-flammable
detergents, intended for automatic scrubber
applications.
MACHINE START AND STOP
Starting the machine
1.
Prepare the machine as shown in the previous paragraph.
2.
Insert the ignition key (A, Figure 8) and turn it to "I".
Check that the green warning light (B) turns on (charged
battery). If the yellow (C) or red warning light (D) turns
on, turn the ignition key back to "0" and charge the
batteries (see the procedure in Maintenance chapter).
3.
Drive the machine to the working area:
By pushing it with the hands on the handlebar (E) (only
•
for machine without traction).
By pushing it with the hands on the handlebar (E) and
•
pressing the switch (F) to move forward, or pressing the
switch (F) together with the switch (G) to move
backward (only for machine with traction). The forward
speed can be adjusted with the adjuster (H).
4.
Lower the squeegee (I) with the lever (J).
5.
Lower the brush/pad-holder deck (K) by lifting the pedal
(L).
6.
Press the brush/pad-holder switch (M) and the vacuum
system switch (N).
7.
Press the washing water flow control switches (O) as
necessary, depending on the type of cleaning to be
performed.
8.
Start cleaning:
(only for machine without traction) by pushing the
•
machine with the hands on the handlebar (E) and
pressing the switch (F).
(only for machine with traction) by pushing the machine
•
with the hands on the handlebar (E) and by pressing the
switch (F). If necessary, the forward speed can be
adjusted with the adjuster (H).
NOTE
To move the machine forward, press either
the left or right switch (F) or both.
B
F
D
A
M
N
K
I
10
ENGLISH
E
A
G
H
Figure 7
D C B
F
G
E
Figure 8
H
O
F
J
L