Care And Cleaning; Cleaning Instructions - Proctor Silex 51000 Manual De Uso

Care and Cleaning

Cleaning Instructions

wWARNING
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result
in death, fire, or electrical shock.
General cleaning
Do not allow food residue to dry on any part of the
blender. Wash and rinse container, cutter unit
assembly and base after each use, or whenever it
will not be used again within one hour, as follows:
1. Remove the container from the base, and then
remove the cover. Add cleaning solution to the
container. Use a washing solution of hot water
(less than 115°F/46°C) and a nonsudsing
detergent. Use the recommended amount of
detergent.
2. Scrub and flush out the container interior,
cover, and filler-cap to remove food residue.
Empty container.
3. Fill container 1 ⁄ full with fresh washing solution
4
and place it on the base.
4. Replace the cover on the container and run
the blender on high speed for 2 minutes.
5. Repeat step 3 using clean rinse water
(95°F/35°C).
6. Wipe down the container, filler-cap, and cover
with a soft cloth or sponge, dampened with
fresh washing solution.
7. Wipe the exterior of the base with a damp cloth
or sponge. The base contains electrical
components: do not immerse and do not use
a high-pressure washer or dishwasher to clean
the base.
wWARNING
Cut Hazard
Always place cover on container when
blending.
Do not put hands, spoons, or other utensils
in container when blending.
Failure to follow these instructions can result
in broken bones, cuts, or other injuries.
Sanitizing
1. Wash container as instructed in "General
cleaning."
2. Fill container with sanitizing solution (see
"Recommended Sanitizing Solution" below)
and place on base.
3. Replace cover and filler-cap and run on LO/1
speed for 2 minutes. Empty container.
4. Wipe the container exterior with a soft cloth or
sponge dampened with sanitizing solution.
5. Immerse the cover and filler-cap in sanitizing
solution for 2 minutes.
6. Remove any remaining moisture from cutter
assembly by placing empty container on base
and running on HI/2 speed for 2 seconds.
7. When ready to use, rinse with clean water.
NOTE: Do not rinse container, cover, or filler-cap
after sanitizing.
Recommended Sanitizing Solution: The sanitizing
solution should consist of 1 tablespoon of
household bleach per 1 gallon of clean, cool water
(60°F, 16°C) mixed according to the instructions on
the bleach. When using a sanitizing solution other
than that recommended, the sanitizing solution
concentration should be tested using commercially
available test strips and should indicate a
concentration between 100 and 200 parts per
million of bleach to water.
7