Publicidad
Idiomas disponibles
Idiomas disponibles
(e.g.use a rigging plate or connectors made for tri-axial loading)
(Figure10C). Always secure the device, protect sharp edges and
do not use a girth hitch (Figure 10D). If the anchor is part of a fall
protection system, use measures to absorb shock loads.
General information
Regular checks:
•
Do not hesitate to dispose of the device if it shows signs of
wear or after an overload or a major impact. These may cause
internal or invisible damage that may significantly weaken its
strength. In case of uncertainty, treat the device as damaged
or consult SKYLOTEC.
•
The device must be checked by an authorised person once
a year. Keep an inspection record for this purpose (see last
page of the user manual). We also recommend that a set of
equipment is used by one person only as its history of use is
best traced and understood in this way.
•
Before each use, you must check the device and ensure that
all its components (handle, jamming cleat, flanges) are
faultless and in good working condition.
Packaging, storage, maintenance and cleaning
Each product is packaged with its INSTRUCTIONS FOR USE.
Proper maintenance and storage are essential to ensure correct
functioning of the product (as well as of all your equipment) and
therefore your safety.
Clean the product with a brush under running cold water from a tap.
If stains persist, clean the product with warm water (maximum
30°C) and ordinary soap. Then rinse thoroughly, wipe it with a towel
and let it dry naturally in a shaded ventilated place away from
sources of heat. If needed, lightly lubricate the moving joints of the
cam and lever with silicon-based oil.
Temperature
The product can be used in a temperature range of -20 °C to +60 °C
(-4 °F to 140 °F). We recommend, however, that you store it in
a dry place at room temperature.
Service life
The service life is set by the date of production and is theoretically
unlimited. The service time starts with the first day of use and
depends on the frequency and type of use, on the environment
(e.g. marine, cave, corrosive surroundings) and on mechanical
wear and damage. The expected service life of a particular device
can therefore not be accurately predicted. Its due retirement
depends on the user's regular examinations and annual inspections
by an authorised person.
15
Publicidad
