apx2121_4241_1301.qxd
7. GLOSSARY
Crossover: A device that limits the range of frequencies sent to a speaker or
amplifier.
dB: decibel, a measurement of the relative difference in power or intensity between
two acoustic signals.
Equalizer: Component that boosts or cuts sound signal frequencies to improve the
quality of the sound.
Gain control: gain is the amount of amplification (voltage, current or power) of an
audio signal expressed in dB.
Hz: Abbreviation for Hertz, a unit of frequency equal to one cycle per second.
Octave: the musical principle of dividing sound frequencies into the eight notes of
the musical scale.
Ohm : unit of electric resistance
RCA input/output: port through which sound travels in and out of the system; "RCA"
refers to the type of connector, which was first manufactured by the Radio
Corporation of America.
Slope: how fast the sound gets quieter rated in dBs. The higher the dB number, the
faster the frequency drops off.
8. SPECIFICATIONS
Note:
The technical data and the design of the equipment may change without
prior notice for the sake of technical improvements.
APX4241
Maximum power output
Continuous rated power *
Typical power in bridged mode **
Typical power in 2-Ohm load **
IM distortion
S/N (A-weighted)
Floor noise
Channel separation
Frequency response
Line level input sensitivity
Speaker level input sensitivity
Input impedance
Allowable battery voltage
Size
* THD
0.1%, 10Hz-20kHz, into 4-Ohms, @ 14.4V, all channels driven
** THD
0.1%, 10Hz-20kHz, @ 14.4V, all channels driven
2/6/2008
11:57 AM
Page 17
400W
60W x 4
100W x 2
80W x 4
0.1%
75dB
A / N
60dB
20-20kHz full range
200mV to 5.5 Volts
2V to 9 Volts
22K Ohm
9.6 to 15.6 Volts
11 7/8"x11"x2 1/4"
17